相关论文: Joint Wireless Information and Energy Transfer wit…

Recently, joint wireless information and energy transfer (JWIET) methods have been proposed to relieve the battery limitation of wireless devices. However, the JWIET in a general K-user MIMO interference channel (IFC) has been unexplored so…

In this paper, we consider a multi-antenna system where the receiver should harvest energy from the transmitter by wireless energy transfer to support its wireless information transmission. In order to maximize the harvesting energy, we…

Simultaneous wireless information and power transfer (SWIPT) is anticipated to have abundant applications in future machine or sensor based wireless networks by providing wireless data and energy access at the same time. In this paper, we…

This paper studies an intelligent reflecting surface (IRS)-assisted multiuser multiple-input single-output (MISO) simultaneous wireless information and power transfer (SWIPT) system. In this system, a multi-antenna access point (AP) uses…

To reap the active and passive beamforming gain in an intelligent reflecting surface (IRS)-aided wireless network, a typical way is to first acquire the channel state information (CSI) relying on the pilot signal, and then perform the joint…

Wirelessly powered backscatter communication (WPBC) has been identified as a promising technology for low-power communication systems, which can reap the benefits of energy beamforming to improve energy transfer efficiency. Existing studies…

Wirelessly powered backscatter communication (WPBC) has been identified as a promising technology for low-power communication systems, which can reap the benefits of energy beamforming to improve energy transfer efficiency. However,…

Wireless energy transfer (WET) has attracted significant attention recently for providing energy supplies wirelessly to electrical devices without the need of wires or cables. Among different types of WET techniques, the radio frequency…

The dual use of radio signals for simultaneous wireless information and power transfer (SWIPT) has recently drawn significant attention. To meet the practical requirement that energy receivers (ERs) operate with much higher received power…

This paper investigates joint wireless information and energy transfer in a two-user MIMO interference channel, in which each receiver either decodes the incoming information data (information decoding, ID) or harvests the RF energy (energy…

This paper studies the simultaneous wireless information and power transfer (SWIPT) in a multiuser wireless system, in which distributed transmitters send independent messages to their respective receivers, and at the same time…

This paper considers the transmitter design for wireless information and energy transfer (WIET) in a multiple-input single-output (MISO) interference channel (IFC). The design problem is to maximize the system throughput (i.e., the weighted…

Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy…

The performance of Simultaneous Wireless Information and Power Transfer (SWIPT) is mainly constrained by the received Radio-Frequency (RF) signal strength. To tackle this problem, we introduce an Intelligent Reflecting Surface (IRS) to…

The dual use of radio signals for simultaneous wireless information and power transfer (SWIPT) has recently drawn significant attention. To meet the practical requirement that energy receivers (ERs) operate with significantly higher…

In this letter, we consider a large-scale multiple-input multiple-output (MIMO) system where the receiver should harvest energy from the transmitter by wireless power transfer to support its wireless information transmission. The energy…

We study RF-enabled wireless energy transfer (WET) via energy beamforming, from a multi-antenna energy transmitter (ET) to multiple energy receivers (ERs) in a backscatter communication system, such as RFID, where each ER (or RFID tag)…

We propose techniques for optimizing transmit beamforming in a full-duplex multiple-input-multiple-output (MIMO) wireless-powered communication system, which consists of two phases. In the first phase, the wireless-powered mobile station…

This letter studies a multi-antenna wireless powered communication (WPC) system with co-channel energy and information transfer, where a wireless device (WD), powered up by wireless energy transfer (WET) from an energy transmitter (ET),…

This paper studies simultaneous wireless information and power transfer (SWIPT) systems in two-way relaying (TWR) channels. Here, two source nodes receive information and energy simultaneously via power splitting (PS) from the signals sent…