相关论文: Method to reduce excess noise of a detuned cavity …
Clock noise is one of the dominant noises in the space-borne gravitational wave (GW) detection. To suppress this noise, the clock noise-calibrated time-delay-interferometry (TDI) technique is proposed. In this technique, an inter-spacecraft…
For broadband quantum noise reduction of gravitational-wave detectors, frequency-dependent squeezed vacuum states realized using a filter cavity is a mature technique and will be implemented in Advanced LIGO and Advanced Virgo from the…
Time-delay interferometry is put forward to improve the signal-to-noise ratio of space-borne gravitational wave detectors by canceling the large laser phase noise with different combinations of measured data. Based on the Michelson data…
Control noise is a limiting factor in the low-frequency performance of the LIGO gravitational wave detectors. In this paper we model the effects of using new sensors called HoQIs to control the suspension resonances. We show if we were to…
KAGRA is a cryogenic interferometric gravitational wave detector being constructed at the underground site of Kamioka mine in Gifu prefecture, Japan. We performed an optimization of the interferomter design, to achieve the best sensitivity…
Onboard electrostatic suspension inertial sensors are important applications for gravity satellites and space gravitational wave detection missions, and it is important to suppress noise in the measurement signal. Due to the complex…
Earth-based gravitational-wave detectors will be limited by quantum noise in a large part of their spectrum. The most promising technique to achieve a broadband reduction of such noise is the injection of a frequency dependent squeezed…
We give a detailed treatment of electromagnetic signals generated by gravitational waves (GWs) in resonant cavity experiments. Our investigation corrects and builds upon previous studies by carefully accounting for the gauge dependence of…
We propose an innovative demodulation scheme for coherent detectors used in cosmic microwave background polarization experiments. Removal of non-white noise, e.g., narrow-band noise, in detectors is one of the key requirements for the…
The sensitivity of future gravitational wave interferometers is expected to be limited through-out the detection band by quantum vacuum fluctuations, which can be reduced by quantum non-demolition methods such as squeezed vacuum injection.…
In our previous research, simulation showed that a quantum locking scheme with homodyne detection in sub-cavities is effective in surpassing the quantum noise limit for Deci-hertz Interferometer Gravitational Wave Observatory (DECIGO) in a…
We propose a new method to detect gravitational waves, based on spatial coherence interferometry with stellar light, as opposed to the conventional temporal coherence interferometry with laser sources. The proposed method detects…
Coating Brownian noise is the dominant noise term, in a frequency band from a few tens to a few hundreds Hz, for all Earth-bound detectors of gravitational waves. Minimizing such noise is mandatory to increase the visibility distance of…
Signal extraction out of background noise is a common challenge in high precision physics experiments, where the measurement output is often a continuous data stream. To improve the signal to noise ratio of the detection, witness sensors…
Gravitational waves might help resolve the tension between early and late Universe measurements of the Hubble constant, and this possibility can be enhanced with a gravitational wave detector in the decihertz band as we will demonstrate in…
The sensitivity achievable by a pair of VIRGO detectors to stochastic and isotropic gravitational wave backgrounds of cosmological origin is discussed in view of the development of a second VIRGO interferometer. We describe a…
Gravitational waves have predominantly been detected using interferometric techniques, with standard approaches limited to 10 kHz and with modern advancements extending this bound to 300 kHz. To explore the largely uncharted…
The Matter-Wave laser Interferometer Gravitation Antenna, MIGA, will be a hybrid instrument composed of a network of atom interferometers horizontally aligned and interrogated by the resonant field of an optical cavity. This detector will…
Cavities in large-scale photonic integrated circuits often suffer from a wider distribution of resonance frequencies due to fabrication errors. It is crucial to adjust the resonances of cavities using post-processing methods to minimize the…
Newtonian noise in gravitational wave detectors originates from density fluctuations in the adjacency of the interferometer mirrors. At the Einstein Telescope, this noise source is expected to be dominant for low frequencies. Its impact is…