相关论文: A combined ultrasonic flow meter and binary vapour…
The ATHENA X-ray Observatory is the second large-class mission in the ESA Cosmic Vision 2015-2025 science programme. One of the two on-board instruments is the X-IFU, an imaging spectrometer based on a large array of TES microcalorimeters.…
In recent years, there has been an increasing research interest in the application of remote sensing technology to highly aerated flows, which is because this technology holds the ultimate promise to enable safe and accurate measurements of…
The inductively-heated plasma generator IPG6-B at Baylor University has been established and characterized in previous years for use as a flexible experimental research facility across multiple applications. The system uses a similar plasma…
This article shows the first measurement of three 100 MHz signals exhibiting fluctuations from 2E-16 to parts in 1E-15 for integration time tau between 1 s and 1 day. Such stable signals are provided by three Cryogenic Sapphire Oscillators…
We report on the development of an instrument for the measurement of the Encircled Angular Flux (EAF) and on establishing its metrological traceability at the required level of uncertainty. We designed and built for that purpose two…
High-frequency ultrasonic pulses at 36 MHz are used to measure velocity profiles in a complex fluid sheared in the Couette geometry. Our technique is based on time-domain cross-correlation of ultrasonic speckle signals backscattered by the…
A method of measuring the thickness of steel plates using through transmission of an acoustic pulse is demonstrated. This study has been done on a stainless steel plate with regions of thickness 10:0 mm, 9:8 mm, and 9:6 mm, using broadband…
The rapidity-even dipolar flow v1 associated with dipole asymmetry in the initial geometry is measured over a broad range in transverse momentum 0.5 GeV<pT<9 GeV, and centrality (0-50)% in Pb-Pb collisions at sqrt(s_NN)=2.76 TeV, recorded…
Wavelength calibration is a key factor for high-resolution spectroscopic measurements for precision radial velocities. Hollow-cathode lamps (e.g., ThAr), absorption cells (e.g., iodine cell), dielectric coated Fabry-P\'erot etalons and…
We report on the experimental study made on a successive prototype of High-Voltage CMOS (HV-CMOS) ATLASPix2 sensor for the tracking detector application, developed with 180 nm feature size. These sensors are to qualify mainly the peripheral…
The model glass-former glycerol and its aqueous mixtures were investigated with terahertz-time domain spectroscopy (THz-TDS) in the frequency range of 0.3--3.0\,THz at temperatures from 80--305\,K. It was shown that the infrared absorption…
This paper studies the effects of mixed convection fluid motion and heat transmission of Al2O3-Water nanofluid in a square enclosure including two heated obstacles, with temperature and nanoparticle concentration being determined by the…
We demonstrate a non-stereoscopic, video-based particle tracking system with optical tweezers to study fluid flow in 3D in the vicinity of glass nanopores. In particular, we used the Quadrant Interpolation algorithm to extend our…
The alignment of tracking detectors is crucial for the physics programme at the LHC, especially for precision measurements like the W mass. The alignment of the ATLAS silicon tracking detectors with a total of 5832 modules poses an…
The ATLAS experiment will undergo a major upgrade of the tracker system in view of the high luminosity phase of the LHC (HL-LHC) to start operation in 2026. The most severe challenges are to be faced by the innermost layers of the pixel…
Experimental measurements and numerical simulations are made on fluid flow through cross-slot devices with a range of aspect (depth:width) ratios, 0.4 < alpha < 3.87. For low Reynolds numbers Re, the flow is symmetric and a sharp boundary…
Purpose: Computational Fluid Dynamics (CFD) simulations are performed to investigate the impact of adding a grid to a two-inlet dry powder inhaler (DPI). The purpose of the paper is to show the importance of the correct choice of closure…
The flow profile in a capillary gap and the pumping efficiency of an acoustic micropump employing Surface Acoustic Waves is investigated both experimentally and theoretically. Such ultrasonic surface waves on a piezoelectric substrate…
To develop a machine sound monitoring system, a method for detecting anomalous sound is proposed. Exact likelihood estimation using Normalizing Flows is a promising technique for unsupervised anomaly detection, but it can fail at…
Modulation is the key element of the comprehensive two-dimensional gas chromatography separation. Forward fill/flush flow modulation is cost effective, robust and suitable for analysis of a wide range of samples. Even though this modulation…