相关论文: Comments on "Bifurcations in DC-DC Switching Conve…

A recent paper [1] (El Aroudi, 2012) misapplied a critical condition (Fang and Abed, 2001) to a well-known example. Even if the mistake is corrected, the results in [1] are applicable only to buck converters and period-doubling bifurcation.…

Three local bifurcations in DC-DC converters are reviewed. They are period-doubling bifurcation, saddle-node bifurcation, and Neimark bifurcation. A general sampled-data model is employed to study the types of loss of stability of the…

Sampled-data analysis and harmonic balance analysis are applied to analyze switching DC-DC converters under constant on-time control. Design-oriented boundary conditions for the period-doubling bifurcation and the saddle-node bifurcation…

The increasing adoption of power electronic devices may lead to large disturbance and destabilization of future power systems. However, stability criteria are still an unsolved puzzle, since traditional small-signal stability analysis is…

Stability guarantees are critical for cycle-by-cycle controlled dc-dc converters in consumer electronics and energy storage systems. Traditional stability analysis on cycle-by-cycle dc-dc converters is incomplete because the inductor…

Design-oriented boundary conditions for subharmonic oscillations are of great interest recently. Based on a subharmonic oscillation boundary condition reported in a PhD thesis more than a decade ago, extended new boundary conditions are…

General scenarios of transitions between different spot patterns on electrodes of dc gas discharges and their relation to bifurcations of steady-state solutions are analyzed. In the case of cathodes of arc discharges, it is shown that any…

This paper addresses stability issues of DC networks with constant power loads (CPL). Common DC networks, such as automotive electrical systems and DC microgrids, typically have a step-up/down converter connected in one side to the main bus…

By transforming an exact stability condition, a new Nyquist-like plot is proposed to predict occurrences of three typical instabilities in DC-DC converters. The three instabilities are saddle-node bifurcation (coexistence of multiple…

In the paper "Andrew D.P. Smith, Peter T. Haugen, Boyd F. Edwards: Hysteretic transition between states of a filled hexagonal magnetic dipole cluster, Journal of Magnetism and Magnetic Materials 549 (2022): 168991" a hysteretic transition…

This paper is an extension of the author's recent research in which only buck converters were analyzed. Similar analysis can be equally applied to other types of converters. In this paper, a unified model is proposed for buck, boost, and…

The paper considers a DC-DC buck power converter employing pulse width modulation and voltage feedback control. Global asymptotical stability of a periodical operating mode is examined. It is shown that the stability analysis can be reduced…

The series-paralleling technique of dc-dc converters is utilized in various domains of electrical engineering for improved power conversion. Previous studies have proposed and classified the control schemes for the series-paralleled…

This article is the second part of a paper series about interference in extremum (i.e., peak or valley) current-mode control, which applies to both fixed and variable switching frequency power converters. Specifically, this part presents…

This paper discusses some aspects of control schemes for voltage source converters under abnormal conditions. The control schemes are developed specifically for the situations when one or more system parameters vary significantly to the…

Study of the buck converter and cascaded system considering the voltage mode controller has been done. First the small signal analysis of a buck dc/dc converter is presented and its mathematical representation has been showed. Then, the…

Power electronic converters are fundamental building blocks of both AC and DC microgrids, enabling the integration of renewable energy sources, energy storage systems, electronic loads, and electric vehicles. In contrast, converter control…

The paper (as posted originally) contains several errors. It has been subsequently split into two papers, the corrected (and accepted for publication) versions appear in the archive as papers cs.CC/0503082 and cs.DM/0503083.

Electromagnetic relays and solenoid actuators are commonly used for their bistable behavior, which allows for switching between two states in electrical, pneumatic, or hydraulic circuits, among other applications. Although there has been…

In this article, we investigate small-signal frequency and DC voltage stability of hybrid AC/DC power systems that combine AC and DC transmission, conventional machine- based generation, and converter-interfaced generation. The main…