相关论文: High Bandwidth Pickup Design for Bunch Arrival-tim…
FPGA-based data processing in datacenters is increasing in popularity due to the demands of modern workloads and the ensuing necessity for specialization in hardware. Driven by this trend, vendors are rapidly adapting reconfigurable devices…
We demonstrate a scheme, based on a cascade of lithium niobate intensity and phase modulators driven by specially tailored radio frequency waveforms to generate an optical frequency comb with very high spectral flatness. In this work we…
In a typical multi-standard military communication receiver, fast and reliable spectrum sensing unit is required to extract the information of multiple channels (frequency bands) present in a wideband input signal. In this paper, an energy…
The high energy beam transport (HEBT) line for the ISAC radioactive beam facility at TRIUMF requires an 11.8 MHz buncher. The main requirements of the buncher are to operate in cw mode with a velocity acceptance of 2.2% and an effective…
In this paper, the design, realization, and demonstration of a broadband millimeter-wave imaging system based on the synthetic aperture radar technique (SAR) are discussed. The proposed system, operating within the frequency range of…
Tunable, low-loss, narrowband, and frequency-stabilized filters play a critical role in the realization of transceivers for efficient signal processing in telecommunications and sensing applications in the presence of strong interference…
A system based on commercially available items, such as a laser diode, emitting in the visible range $\sim 400$ nm,and multimode fiber patches, fused fiber splitters and optical switches may be assembled,for time calibration of…
A new bunch length measurement method based on high order mode cavity was proposed. Operating the harmonic cavity at mode TM0n0 so that its radius could be chosen, in order to break the limitation of beam pipe radius. A two-cavity bunch…
Envisioned for fifth generation (5G) systems, millimeter-wave (mmWave) communications are under very active research worldwide. Although pencil beams with accurate beamtracking may boost the throughput of mmWave systems, this poses great…
The nano-meter beam size in future linear colliders requires very high resolution beam position monitor since higher resolution allows more accurate position measurement in the interaction point. We developed and tested a low-Q C-band beam…
We here propose and demonstrate a point-by-point programmable broadband microwave spectrum processor with high-resolution up to tens of MHz. We achieve this by bandwidth-minified mapping a programmable optical spectrum processor, which has…
In continuous-variable quantum information processing, it is crucial to develop high-efficiency and broadband quantum memory of squeezed light, which enables the storage of full-bandwidth information. Here, we present a quantum memory of…
A 60 GHz wireless Gigabit Ethernet (G.E.) communication system capable of near gigabit data rate has been developed at IETR. The realized system covers 2 GHz available bandwidth. This paper describes the design and realization of the…
We propose to achieve joint detections of frequency and direction of arrival in wideband using single sensor based on an active metasurface with programmable transmission states of pass and stop. By integrating two PIN diodes with the…
The Compressed Baryonic Matter (CBM) experiment is designed to handle interaction rates of up to 10 MHz and up to 1 TB/s of raw data generated. With triggerless streaming data acquisition in the experiment and beam intensity fluctuations,…
We have operated a quantum point contact (QPC) charge detector in a radio frequency (RF) mode that allows fast charge detection in a bandwidth of tens of megahertz. We find that the charge sensitivity of the RF-QPC is limited not by the…
We present a comprehensive theory and an easy to follow method for the design and construction of a wideband homodyne detector for time-domain quantum measurements. We show how one can evaluate the performance of a detector in a specific…
A new method of controllable injection to generate high quality electron bunches in the nonlinear blowout regime driven by electron beams is proposed and demonstrated using particle-in-cell simulations. Injection is facilitated by…
To achieve multi-Gb/s data rates in 6G optical wireless access networks based on narrow infrared (IR) laser beams, a high-speed receiver with two key specifications is needed: a sufficiently large aperture to collect the required optical…
The 30 and 44 GHz Back End Modules (BEM) for the Planck Low Frequency Instrument are broadband receivers (20% relative bandwidth) working at room temperature. The signals coming from the Front End Module are amplified, band pass filtered…