相关论文: Real-Time Stress Measurements in Lithium-ion Batte…
An in situ study of stress evolution and mechanical behavior of germanium as a lithium-ion battery electrode material is presented. Thin films of germanium are cycled in a half-cell configuration with lithium metal foil as counter/reference…
We report real-time average stress measurements on composite silicon electrodes made with two different binders [Carboxymethyl cellulose (CMC), and polyvinylidene fluoride (PVDF)] during electrochemical lithiation and delithiation. During…
Composite cathode coatings made of a high energy density layered oxide (Li1.2Ni0.15Mn0.55Co0.1O2, theoretical capacity ~377 mAh/g), polyvinylidene fluoride (PVdF) binder, and electron-conduction additives, were bonded to an elastic…
We report in situ measurements of stress evolution in a silicon thin-film electrode during electrochemical lithiation and delithiation by using the Multi-beam Optical Sensor (MOS) technique. Upon lithiation, due to substrate constraint, the…
In a pouch cell battery, the intercalation of lithium ions into the active particles means the electrodes want to expand. However, since the electrodes are attached to stiff current collectors, this expansion is constrained, leading to a…
An in situ study of deformation, fracture, and fatigue behavior of silicon as a lithium-ion battery electrode material is presented. Thin films (100-200 nm) of silicon are cycled in a half-cell configuration with lithium metal foil as…
Crystalline to amorphous phase transformation during initial lithiation in (100) silicon-wafers is studied in an electrochemical cell with lithium metal as the counter and reference electrode. It is demonstrated that severe stress jumps…
Li-ion batteries are ineluctably subjected to external mechanical loading or stress gradient. Such stress can be induced in battery electrode during fabrication and under normal operation. In this paper, we develop a model for stresses…
An analysis of the dependence of electric potential on the state of stress of a lithiated-silicon electrode is presented. Based on the Larch\'e and Cahn chemical potential for a solid solution, a thermodynamic argument is made for the…
Next-generation lithium-ion batteries with silicon anodes have positive characteristics due to higher energy densities compared to state-of-the-art graphite anodes. However, the large volume expansion of silicon anodes can cause high…
We report in situ measurement of biaxial moduli of a Si thin-film electrode as a function of its lithium concentration. During lithiation, biaxial compressive stress is induced in the Si film and it undergoes plastic flow. At any…
Energy efficient, safe and reliable Li-ion batteries (LIBs) are required for a wide range of applications. Charging capabilities of thick electrodes still holding their stored high-energy is a most desirable characteristic in future…
We report the lithium plating associated capacity loss during fast charging of compressively loaded lithium-ion batteries (LIBs). The charging and discharging of LIB under compressive loading during service may affect the cell performance…
We formulate the continuum field equations and constitutive equations that govern deformation, stress, and electric current flow in a Li-ion half-cell. The model considers mass transport through the system, deformation and stress in the…
Lithium intercalation into graphite is the foundation for the lithium-ion battery, and the thermodynamics of the lithiation of graphitic electrodes have been heavily investigated. Intercalated lithium in bulk graphite undergoes structural…
We present measurements of the dynamical response of thermal noise to an ac excitation in conductors at low temperature. From the frequency dependence of this response function - the noise thermal impedance - in the range 1 kHz-1 GHz we…
We investigate the conditional evolution of a charge state coupled to a mesoscopic detector under continuous weak measurement. The state suffers relaxation into a particular state with a definite charge when electrons in a particular output…
A general framework to study the mechanical behaviour of a cylindrical silicon anode particle in a lithium ion battery as it undergoes lithiation is presented. The two-way coupling between stress and concentration of lithium in silicon,…
Compression experiments are widely used to study the mechanical properties of materials at micro- and nanoscale. However, the conventional engineering stress measurement method used in these experiments neglects to account for the…
Accurate tracking of the internal electrochemical states of lithium-ion battery during cycling enables advanced battery management systems to operate the battery safely and maintain high performance while minimizing battery degradation. To…