相关论文: Introduction of a DC Bias into a High-Q Supercondu…
We report a technique for applying a dc bias in a 3d microwave cavity. This is achieved by isolating the two halves of the cavity with a dielectric and directly using them as dc electrodes. By embedding a variable capacitance diode in the…
We report on a technique for applying a DC bias in a 3D microwave cavity. We achieve this by isolating the two halves of the cavity with a dielectric and directly using them as DC electrodes. As a proof of concept, we embed a variable…
Three-dimensional microwave waveguide cavities are essential tools for many cavity quantum electrodynamics experiments. However, the need to control quantum emitters with dc magnetic fields inside the cavity often limits such experiments to…
We report a technique that can noninvasively add multiple DC wires into a 3D superconducting microwave cavity for electronic devices that require DC electrical terminals. We studied the influence of our DC lines on the cavity performance…
We present the design of a reflective stop-band filter based on quasi-lumped elements that can be utilized to introduce large dc and low-frequency voltage biases into a low-loss superconducting coplanar waveguide (CPW) cavity. Transmission…
Superconducting microwave cavities have found applications in many areas including quantum computing, particle accelerators, and dark matter searches. Their extremely high quality factors translate to very narrow bandwidth, which makes them…
Three-dimensional (3D) superconducting microwave cavities with large mode volumes typically have high quality factors ($>10^6$). This is due to a reduced sensitivity to surface dielectric losses, which is the limiting source of dissipation…
In many hybrid quantum systems, a superconducting circuit is required that combines DC-control with a coplanar waveguide (CPW) microwave resonator. The strategy thus far for applying a DC voltage or current bias to microwave resonators has…
We propose a superconducting diode device comprising a central superconducting film flanked by two wires carrying an applied DC bias, suitably chosen so as to generate different asymmetric field profiles. Through numerical simulations of…
A wide variety of applications of microwave cavities, such as measurement and control of superconducting qubits, magnonic resonators, and phase noise filters, would be well served by having a highly tunable microwave resonance. Often this…
We report a two-stage, heterodyne rf-to-microwave transducer that combines a tunable electrostatic pre-amplifier with a superconducting electromechanical cavity. A metalized Si$_3$N$_4$ membrane (3 MHz frequency) forms the movable plate of…
An analog crystal filter based cavity emulator is modified with reverse biased varactor diodes to provide a tuning range of around 160 Hz. The piezo drive voltage of the resonance controller is used to detune the cavity through the bias…
We demonstrate a superconducting (SC) microwave (mw) cavity that can accelerate the dark matter search by maintaining superconductivity in a high DC magnetic field. We used high-temperature superconductor (HTSC) yttrium barium copper oxide…
Frequency tunability of 3D microwave cavities opens up numerous possibilities for their use in hybrid quantum systems and related technologies. For many applications it is desirable to tune the resonance at cryogenic temperatures without…
We fabricated superconducting coplanar waveguide resonator with leads for dc bias, which enables the ac conductivity measurement under dc bias. The current and the magnetic field dependences of resonance properties were measured, and…
We present the design, measurement and analysis of a current sensor based on a process of Josephson parametric upconversion in a superconducting microwave cavity. Terminating a coplanar waveguide with a nanobridge constriction Josephson…
We present a comprehensive study of internal quality factors in superconducting stub-geometry 3-dimensional cavities made of aluminum. We use wet etching, annealing and electrochemichal polishing to improve the as machined quality factor.…
We design and test a low-loss interface between superconducting 3-dimensional microwave cavities and 2-dimensional circuits, where the coupling rate is highly tunable. This interface seamlessly integrates a loop antenna and a Josephson…
In the context of engineered quantum systems, there is a demand for superconducting tunable devices able to operate with high Q-factors at power levels equivalent to only a few photons. In this work, we developed a 3D microwave reentrant…
We demonstrate a hybrid device architecture where the charge states in a double quantum dot (DQD) formed in a Si/SiGe heterostructure are read out using an on-chip superconducting microwave cavity. A quality factor Q = 5,400 is achieved by…