相关论文: Third Harmonic Cavity Modal Analysis

Third harmonic superconducting cavities have been designed and fabricated by FNAL to minimise the energy spread along bunches in the FLASH facility at DESY. A module, consisting of four nine-cell 3.9 GHz cavities, has been installed in…

The third harmonic nine-cell cavity (3.9 GHz) for FLASH and the European XFEL has been investigated using simulations performed with the computer code CST Microwave Studio. The band structure of monopole, dipole, quadrupole and sextupole…

We analyse higher order modes in the 3.9 GHz bunch shaping cavities recently installed in the FLASH facility at DESY. We report on recent experimental results on the frequency spectrum from probe based measurements made at CMTB at DESY.…

The resonant modes in the 9cell 3.9GHz bunch shaping cavity designed by FERMILAB in collaboration with DESY [1] and installed in FLASH at DESY were calculated up to the range of 10GHz in terms of the band structure of this design. The modal…

Transverse modes in the 3.9 GHz cavities, designed and fabricated by FNAL, are reported on. These modes have the potential to cause significant emittance dilution if they are not sufficiently suppressed. Recent probe-based-experiments have…

Off-axis beams passing through an accelerating cavity excite dipole modes among other higher order modes (HOMs). These modes have linear dependence on the transverse beam offset from the cavity axis. Therefore they can be used to monitor…

This paper presents a study of beam alignment in accelerating cavities based on beam-excited higher order modes (HOM). Among the transverse HOMs, dipole modes have the dominant contribution, and may have an adverse effect on the beam…

This study is focused on the development of a HOM-based BPM system for the ACC39 module currently installed and in operation at FLASH. A similar system is anticipated to be installed at XFEL. Coupled inter-cavity modes are simulated…

An international team is currently investigating the best way to use Higher Order Modes (HOM) for beam diagnostics in 3.9 GHz cavities. HOMs are excited by charged particles when passing through an accelerating structure. Third harmonic…

An electron beam entering an accelerator cavity excites higher order modes (HOM). These are radiated to HOM couplers and subsequently damped. They can also be used to facilitate beam position monitoring. The modes excited by off-axis beams…

We analyse the higher order modes (HOM's) in the 3.9GHz bunch shaping cavities installed in the FLASH facility at DESY. A suite of finite element computer codes (including HFSS and ACE3P) and globalised scattering matrix calculations (GSM)…

FLASH plans to use a "third harmonic" (3.9GHz) superconducting cavity to compensate nonlinear distortions of the longitudinal phase space due to the sinusoidal curvature of the the cavity voltage of the TESLA 1.3GHz cavities. Higher order…

We present the design and characterization of a dual-mode radiofrequency (rf) cavity, a novel electromagnetic structure with potential benefits such as compactness, efficiency, cost reduction and multifunctionality. The cavity was designed…

An electron beam entering an accelerating cavity excites a wakefield. This wakefield can be decomposed into a series of multi-poles or modes. The dominant component of the transverse wakefield is dipole. This report summarizes the higher…

For the development of the X-ray Free Electron Lasers test facility (SXFEL) at SINAP, ultra-short bunch is the crucial requirement for excellent lasing performance. It's a big challenge for deflecting cavity to measure the length of…

Phase-matching of the third-harmonic generation process can be used to extend the emission of radiation from Kerr microresonators into new spectral regions far from the pump wavelength. Here, we present a theoretical mean-field model for…

Multimode hollow microcavities in three-dimensional (3D) photonic crystals (PhCs) are designed for achieving enhanced coherent anti-Stokes Raman scattering, which requires a cavity to have three high quality-factor (Q) modes with equally…

In this paper, we propose a microcavity supported by a designed photonic crystal structure (PhC) that supplies both tunability of cavity modes and quality factor of cavity. Low symmetric defect region provides a trigger effect for the…

A second harmonic RF cavity which uses perpendicularly biased garnet for frequency tuning is currently being constructed for use in the Fermilab Booster. The cavity will operate at twice the fundamental RF frequency, from ~76 - 106 MHz, and…

Microwave cavities used in axion haloscope experiments typically employ a tuning rod as a means to widen the range of resonance frequencies at which it is sensitive to axion-to-photon conversion. A realistic tuning mechanism requires a gap…