相关论文: X-band crab cavities for the CLIC beam delivery sy…

A crab cavity is required in the CLIC to allow effective head-on collision of bunches at the IP. A high operating frequency is preferred as the deflection voltage required for a given rotation angle and the RF phase tolerance for a crab…

Crab cavities have been proposed for a wide number of accelerators and interest in crab cavities has recently increased after the successful operation of a pair of crab cavities in KEK-B. In particular crab cavities are required for both…

The compact linear collider (CLIC) requires a crab cavity to align bunches prior to collision. The bunch structure demands tight amplitude and phase tolerances of the RF fields inside the cavity, for the minimal luminosity loss. Beam…

The CLIC linear collider aims at accelerating multiple bunches of electrons and positrons and colliding them at a centre of mass energy of 3 TeV. These bunches will be accelerated through X-band linacs, operating at an accelerating…

Beam collisions with a crossing angle at the interaction point have been applied in high intensity colliders to reduce the effects of parasitic collisions which induce emittance growth and beam lifetime deterioration. The crossing angle…

Studies of the crab cavities at KEKB revealed that the RF phase could shift by up to 50o within ~50 us during a quench; while the cavity voltage is still at approximately 75% of its nominal amplitude. If such a failure were to occur on the…

The number of cells in a $\pi$-mode standing wave (SW) accelerating structure for the Compact linear Collider (CLIC) project is limited by mode overlap with nearby modes. The distributed coupling scheme avoids mode overlap by treating each…

Operating the SLAC/KEK DDS (Damped Detuned Structure) X-band linacs at high gradients (in excess of 70MV/m) has recently been found to be limited by the accelerator structures breaking down and as a consequence severe damage occurs to the…

Crab cavities have been installed in the KEKB B--Factory rings to compensate the crossing angle at the collision point and thus increase luminosity. The beam operation with crab crossing has been done since February 2007. This is the first…

This paper outlines the RF design of the CLIC (Compact Linear Collider) 30 GHz main linac accelerating structure and gives the resulting longitudinal and transverse mode properties. The critical requirement for multibunch operation, that…

The continue wave (CW) high current proton linac has wide applications as the front end of the high power proton machines. The low energy part is the most difficult one and there is no widely accepted solution yet. Based on the analysis of…

The crab-waist collision scheme has been the baseline choice for SuperKEKB and future circular $e^+e^-$ colliders. Achieved through properly phased sextupoles, the crab-waist transform is essential in suppressing beam-beam resonances,…

We report on suppression of long-range wakefields in CLIC accelerating structures. Strong detuning and moderate damping is employed. In these initial design studies we focus on the CLIC_G structure and enforce a moderate Q of 300 and 500.…

In order to mitigate the effects of electrical breakdown (which have been found to occur in SLAC X-band traveling wave structures) standing wave structures are being considered for the NLC linac. At SLAC, structures consisting of 15 cells…

Crab crossing scheme is an essential collision scheme to achieve high luminosity for the future colliders with large crossing angles. However, when bunch length of one or both colliding beams is comparable with the wavelength of the crab…

The present design of the main accelerating structure for CLIC is based on heavy damping (WDS) with a Q of ~10. The wakefield suppression in this case entails locating the damping materials in relatively close proximity to the accelerating…

In the NLC (Next Linear Collider) small misalignments in each of the individual accelerator structures (or the accelerator cells) will give rise to wakefields which kick the beam from its electrical axis. This wakefield can cause BBU (Beam…

The CLIC study of a high-energy (0.5 - 5 TeV), high-luminosity (1034 - 1035 cm-2 sec-1) e+e- linear collider is presented. Beam acceleration using high frequency (30 GHz) normal-conducting structures operating at high accelerating fields…

A damped detuned structure for the main X-band linacs of CLIC is being investigated as an alternative design to the present baseline heavily damped structure. In our earlier designs we studied detuned structures, operating at 11.994 GHz,…

Compensation of multi-bunch beam loading is of great importance in the main linac of the Compact Linear Collider (CLIC). The bunch-to-bunch energy variation has to stay below 1 part in 1000. In CLIC, the RF power is obtained by decelerating…