相关论文: Arsenite sorption and co-precipitation with calcit…
Monte Carlo (MC) simulations have been carried out to study the adsorption on square and triangular lattices of particles with two bonding sites that, by decreasing temperature or increasing density, polymerize reversibly into chains with a…
We investigate the chemical and structural configuration of acetophenone on Si(001) using synchrotron radiation core-level spectroscopy techniques and density functional theory calculations. Samples were prepared by vapour phase dosing of…
This thesis was focused on the surface modification with plasma discharge. Austenitic AISI 316L stainless steel sample was carburised under different experimental conditions and mechanical properties have been studied (thickness, lattice…
B-doped $\delta$-layers were fabricated in Si(100) using BCl$_{3}$ as a dopant precursor in ultrahigh vacuum. BCl$_{3}$ adsorbed readily at room temperature, as revealed by scanning tunneling microscopy (STM) imaging. Annealing at elevated…
A sensitive laser spectroscopic method has been applied to the quantitative determination of the isotope ratio of helium at the level of 3He/4He = 10^-7 - 10^-5. The resonant absorption of 1083 nm laser light by the metastable 3He atoms in…
The local environment and oxidation state of the Fe impurity in strontium titanate are studied using XAFS spectroscopy. The influence of annealing temperature and deviation from stoichiometry on the possibility of incorporation of the…
We trap cold, ground-state, argon atoms in a deep optical dipole trap produced by a build-up cavity. The atoms, which are a general source for the sympathetic cooling of molecules, are loaded in the trap by quenching them from a cloud of…
Alkane mixtures are model systems where the influence of surface tension gradients during the spreading and the evaporation of wetting drops can be easily studied. The surface tension gradients are mainly induced by concentration gradients,…
We present a model treating the kinetics of adsorption of soluble surface-active molecules at the interface between an aqueous solution and another fluid phase. The model accounts for both the diffusive transport inside the solution and the…
Metal nanoparticle surfaces comprise of multiple planes with various atomic arrangements that interact with gases differently1,2. Identification of gas adsorption properties on all facets is an essential prerequisite for rational design of…
In the quest to understand the formation of the building blocks of life, amorphous solid water (ASW) is one of the most widely studied molecular systems. Indeed, ASW is ubiquitous in the cold interstellar medium (ISM), where ASW-coated dust…
Many experimental studies of protein deposition on solid surfaces involve alternating adsorption/desorption steps. In this paper, we investigate the effect of a desorption step (separating two adsorption steps) on the kinetics, the…
Future laser-interferometric gravitational wave detectors (GWDs) will potentially employ test mass mirrors from crystalline silicon and a laser wavelength of $1550\,\rm{nm}$, which corresponds to a photon energy below the silicon bandgap.…
We present x-ray reflectivity and diffuse scattering measurements from the liquid surface of pure potassium. They strongly suggest the existence of atomic layering at the free surface of a pure liquid metal with low surface tension. Prior…
We report on cooling of an atomic cesium gas closely above an evanescent-wave. Our first evaporation experiments show a temperature reduction from 10muK down to 300nK along with a gain in phase-space density of almost two orders of…
Massive stars can form within or be captured by AGN disks, influencing both the thermal structure and metallicity of the disk environment. In a previous work, we investigated isotropic accretion onto massive stars from a gas-rich,…
Hypothesis: Evaporation of surfactant droplets on leaves is complicated due to the complex physical and chemical properties of the leaf surfaces. However, for certain leaf surfaces for which the evaporation process appears to follow the…
Pulsed laser ablation is an increasingly prevalent method for fast ion trap loading of various species, however characteristics of the ablation target source material can affect the ion-loading process. One factor which can reduce the…
We show here for the first time the use of a cold sintering process (CSP) to sinter CoSb3-based thermoelectric materials. CSP at 150 {\deg}C for 90 min under a uniaxial pressure of 750 MPa yields pieces with a relative density of 86 %,…
Using mesoscopic numerical simulations and analytical theory we investigate the coarsening of the solvent structure around a colloidal particle emerging after a temperature quench of the colloid surface. Qualitative differences in the…