Related papers: Final Size Planar Edgeless Silicon Detectors for t…
The CERN Large Hadron Collider (LHC) is designed to collide proton beams of unprecedented energy, in order to extend the frontiers of high-energy particle physics. During the first very successful running period in 2010--2013, the LHC was…
Feature sizes in integrated circuits have decreased substantially over time, and it has become increasingly difficult to three-dimensionally image these complex circuits after fabrication. This can be important for process development,…
Silicon tracking detectors have grown to cover larger surface areas up to hundreds of square meters, and are even taking over other sub-detectors, such as calorimeters. However, further improvements in tracking detector performance are more…
There exists an enormous interest for the study of very high energy domain in particle physics, both theoretically and experimentally, in the aim to construct a general theory of the fundamental constituents of matter and of their…
This article proposes a new method to measure the proton detector efficiency for use in "beam" determinations of the free neutron lifetime. There is currently a 4{\sigma} disagreement between the "beam" and "storage" methods of measuring…
We complete the model-independent analysis of the scaling properties of the differential cross section of elastic proton-proton cross sections, including new TOTEM data published in 2022 at $\sqrt{s} = 8$ TeV. We separate the signal and the…
Numerous searches for new phenomena have been carried out using data from proton-antiproton collisions at Fermilab's Tevatron. Final states with leptons give signatures which are relatively unique and generally have small backgrounds. We…
The Precision Proton Spectrometer (PPS) of the CMS and TOTEM experiments collected 107.7 fb$^{-1}$ in proton-proton (pp) collisions at the LHC at 13 TeV (Run 2). This paper describes the key features of the PPS alignment and optics…
The vertex detectors are crucial detectors for future linear e+e- colliders since they must give the most accurate location of any outgoing charged particles originating from the interaction point. The DEPFET collaboration is developing a…
CMOS Pixel Sensors tend to become relevant for a growing spectrum of charged particle detection instruments. This comes mainly from their high granularity and low material budget. However, several potential applications require a higher…
Radiation hard n-Fz Double Sided Silicon microstrip Detectors are used at the Silicon Tracker for the detection of two-dimensional position and energy measurement of the incident protons in the R3B experiment at FAIR, Darmstadt, Germany.…
Superconducting strip single-photon detectors (SSPDs) are excellent tools not only for single-photon detection but also for single-particle detection owing to their high detection efficiency, low dark counts, and low time jitter. Although…
The next generation of very-short-baseline reactor experiments will require compact detectors operating at surface level and close to a nuclear reactor. This paper presents a new detector concept based on a composite solid scintillator…
We report the test results for a 120 GeV proton beam incident on superconducting nanowire particle detectors of various wire sizes. NbN devices with the same sensitive area were fabricated with different wire widths and tested at a…
Recent results are summarized from the TOTEM experiment at CERN LHC, including measurements of the total, elastic and inelastic cross-sections, the nuclear slope parameter $B$, the differential cross-section of elastic scattering and the…
We propose a new strategy to systematically search for new physics processes in particle collisions at the energy frontier. An examination of all possible topologies which give identifiable resonant features in a specific final state leads…
DEPFET pixel detectors are unique devices in terms of energy and spatial resolution because very low noise (ENC = 2.2e at room temperature) operation can be obtained by implementing the amplifying transistor in the pixel cell itself. Full…
The collimation system is an essential part of the design of any high-power accelerator. Its functions include protection of components from accidental and intentional energy deposition, reduction of backgrounds, and beam diagnostics.…
We present the results of our recent studies on a Thick Gas Electron Multiplier (THGEM)-based imaging detector prototype. It consists of two 100x100 mm^2 THGEM electrodes in cascade, coupled to a resistive anode. The event location is…
The ion beam induced charge technique with proton microprobe is used to characterise newly developed p-n junction large area silicon carbide detectors. They were recently produced as part of the ongoing program to develop a new particle…