Related papers: Room-temperature tunnel current amplifier and expe…
A theoretical description of scanning tunneling potentoimetry (STP) measurement is presented to address the increasing need for a basis to interpret experiments on macrscopic samples. Based on a heuristic understanding of STP provided to…
Quantifying the temperature of microdevices is critical for probing nanoscale energy transport.Such quantification is often accomplished by integrating resistance thermometers into microdevices. However, such thermometers frequently become…
Access to lower temperatures has consistently enabled scientific breakthroughs. Pushing the limits of \emph{on-chip} temperatures deep into the microkelvin regime would open the door to unprecedented quantum coherence, novel quantum states…
Single-photon terahertz (THz) detection is one of the most demanding technology for a variety of fields and could lead to many breakthroughs. Although its significant progress has been made in the last two decades, operating it at room…
Indium arsenide nanowires grown by selective-area vapor phase epitaxy are used as tips for scanning tunneling microscopy (STM). The STM tips are realized by positioning the wires manually on the corner of a double cleaved gallium arsenide…
An AC susceptometer operating in the range of 10 Hz to 100 kHz and at room temperature is designed, built, calibrated and used to characterize the magnetic behaviour of coated magnetic nanoparticles. Other weakly magnetic materials (in…
We introduce a zero-bias superconducting voltage amplifier that harvests energy from a thermal gradient by exploiting negative differential resistance (NDR) in an asymmetric tunnel junction. The device is based on an asymmetric…
Investigation of transport properties is fundamental for characterizing electronic properties and phase transitions. However, most of the transport measurements on conductive layers have been performed at macroscopic scales, and thus the…
Surface temperature measurements were performed with a Scanning Thermal Microscope mounted with a thermoresistive wire probe of micrometrSurface temperature measurements were performed with a Scanning Thermal Microscope mounted with a…
We numerically investigate the possibility of using Tunnel field-effect transistor (TFET) in a 32 kHz crystal oscillator circuit to reduce power consumption. A simulation using SPICE (Simulation Program with Integrated Circuit Emphasis) is…
Scanning Thermal Microscopy (SThM) uses micromachined thermal sensors integrated in a force sensing cantilever with a nanoscale tip can be highly useful for exploration of thermal management of nanoscale semiconductor devices. As well as…
We present tunneling measurements of sub-micron metal/insulator/graphene planar tunnel junctions up to room temperature. We observe a gate independent gap, as previously observed only by low temperature STM[Y. Zhang et al., Nat. Phys. 4,…
The Fowler-Nordheim tunneling current formula has been widely used in the design of devices based on metal/insulator (metal/semiconductor) heterojunctions with triangle potential barriers, such as the flash memory. Here we adopt the model…
Measurements of current-voltage (I-V) characteristics of a high quality Al/Al$_2$O$_3$/Al junction at temperatures ranging from 3.5 K to 300 K have been used to extract the barrier properties. Fitting results using Simmons' model led to a…
We present a new concept of scanning thermal nanoprobe that utilizes the extreme thermal conductance of a carbon nanotube (CNT) to channel heat between the probe and the sample. The integration of CNT in scanning thermal microscopy (SThM)…
Recently, several groups have reported spin-dependent thermoelectric effects in magnetic tunnel junctions. In this paper, we present a setup for time-resolved measurements of thermovoltages and thermocurrents of a single micro- to…
A way to increase the Scanning Thermal Microscope (SThM) sensitivity in the harmonic 3w mode is to heat the probe with an AC current sufficiently high to generate a coupling between the AC and the DC signals. We detail in this paper how to…
We demonstrate millikelvin thermometry of laser cooled trapped ions with high-resolution imaging. This equilibrium approach is independent of the cooling dynamics and has lower systematic error than Doppler thermometry, with \pm5 mK…
Optical transition-edge sensors have shown energy resolution for resolving the number of incident photons at the telecommunication wavelength. Higher energy resolution is required for biological imaging and microscope spectroscopy. In this…
Spin-polarized charge-currents induce magnetic tunnel junction (MTJ) switching by virtue of spin-transfer-torque (STT). Recently, by taking advantage of the spin dependent thermoelectric properties of magnetic materials, novel means of…