Related papers: A Method to check the Connectivity for the ATLAS T…

Transition-edge sensor (TES) is a highly sensitive device that is capable of detecting extremely low levels of energy. It is characterised by low noise performance and high energy resolution. A mature method for reading out TES signal is…

Small-diameter Drift Tube (sMDT) detectors with 15 mm tube diameter have proven to be excellent candidates for precision muon tracking detectors in experiments at future hadron colliders like HL-LHC and FCC-hh where unprecedentedly high…

The ATLAS detector is one of the experiments at the LHC that will detect high-energy proton collisions at 14 TeV. The commissioning of the detector has started already in 2005 in parallel to the detector installation and is still in…

The performace of an ATLAS-A silicon micro-strip detector prototype with FELIX 128 analogue read out chip has been studied. The noise level and the signal to noise ratio have been measured as a funtion of both detector bias and temperature.…

A whole range of attacks becomes possible when adversaries gain physical access to computing systems that process or contain sensitive data. Examples include side-channel analysis, bus probing, device cloning, or implanting hardware…

The Rapid Telescope for Optical Response (RAPTOR) program consists of a network of robotic telescopes dedicated to the search for fast optical transients. The pilot project is composed of three observatories separated by approximately 38…

The ATLAS experiment at the LHC will replace its current inner tracker system for the HL-LHC era. 3D silicon pixel sensors are being considered as radiation-hard candidates for the innermost layers of the new fully silicon-based tracking…

FASER (ForwArd Search ExpeRiment) fills the axial blindspot of other, radially arranged LHC experiments. It is installed 480 meters from the ATLAS interaction point, along the collision axis. FASER will search for new, long-lived particles…

This paper presents the design and simulation results of a gigabit transceiver Application Specific Integrated Circuit (ASIC) called GBCR for the ATLAS Inner Tracker (ITk) Pixel detector readout upgrade. GBCR has four upstream receiver…

This contribution introduces a novel test system developed to evaluate the signal transmission quality in high-speed data links for the 2026 Inner Tracker (ITk) upgrade of the ATLAS experiment. Using an FPGA-based data acquisition (DAQ)…

An overview of top quark production measurements using the ATLAS detector at the LHC is presented. Using 35 pb^-1 of data, we measured the ttbar cross-section in the lepton+jets channel to 13% precision and set limits on the cross-section…

The ATLAS pixel detector consists of 1744 identical silicon pixel modules arranged in three barrel layers providing coverage for the central region, and three disk layers on either side of the primary interaction point providing coverage of…

We present a gigabit transceiver prototype Application Specific Integrated Circuit (ASIC), GBCR, for the ATLAS Inner Tracker (ITk) Pixel detector readout upgrade. GBCR is designed in a 65-nm CMOS technology and consists of four upstream…

The amount of data produced by highly granular silicon tracking detectors in high energy physics experiments poses a major challenge to readout systems. At high collision rates, e.g. at LHC experiments, only a small fraction of data can be…

For the muon spectrometer of the ATLAS detector at the large hadron collider (LHC), large drift chambers consisting of 6 to 8 layers of pressurized drift tubes are used for precision tracking covering an active area of 5000 m2 in the…

The LHCb Outer Tracker is a gaseous detector covering an area of 5x6 m2 with 12 double layers of straw tubes. The detector with its services are described together with the commissioning and calibration procedures. Based on data of the…

In this paper we discuss the use of linked thermal and electrical network models to predict the behaviour of a complex silicon detector system. We use the silicon strip detector for the ATLAS Phase-II upgrade to demonstrate the application…

This paper presents experimental and simulation data to characterize the Ring Oscillators (RO) produced in 65-nm CMOS technology for the next promising generation of readout chips for the pixel detector in the Inner Tracker (ITk) at the…

Production of the High Granularity Timing Detector for the ATLAS experiment at High Luminosity LHC requires over 21000 silicon sensors based on Low Gain Avalanche Diode (LGAD) technology. Their radiation hardness is monitored as a part of…

Each time that an intrusion detection system raises an alert it must make some attempt to communicate the information to an operator. This communication channel can easily become the target of a denial of service attack because, like all…