Related papers: A Method to check the Connectivity for the ATLAS T…

This paper presents a readout system designed for testing the prototype of Small-Strip Thin Gap Chamber (sTGC), which is one of the main detector technologies used for ATLAS New-Small-Wheel Upgrade. This readout system aims at testing one…

ATLAS is one of the two general purpose detectors at the world's largest particle accelerator, the Large Hadron Collider (LHC). The LHC will be colliding proton beams at a center of mass energy {\surd}s= 14 TeV and is currently operating at…

A demonstrator for each slice of the ATLAS pixel detector was built to replicate the real detector and provide early solutions for operating and maintaining its components. This system-level testing of the all-silicon Inner Tracker (ITk)…

Many computing systems need to be protected against physical attacks using active tamper detection based on sensors. One technical solution is to employ an ATR (Anti-Tamper Radio) approach, analyzing the radio wave propagation effects…

Following the Phase-II upgrade during Long Shutdown (LS3), the LHC aims to reach a peak instantaneous luminosity of $7.5\times 10^{34}$cm$^{-2}$s$^{-1}$, which corresponds to an average of around 200 inelastic proton-proton collisions per…

Measurements of the branching ratios of top quark decays into leptons and jets using events with $t \overline{t}$ (top antitop) pairs are reported. Events were recorded with the ATLAS detector at the LHC in pp collisions at a center-of-mass…

Measurement of the inclusive and differential top-quark charge asymmetry is carried out using full Run 2 data from proton-proton collisions at a center-of-mass energy of $13$ TeV collected by the ATLAS detector. The single-lepton and…

The contruction of the ATLAS Pixel Detector which is the innermost layer of the ATLAS tracking system is prgressing well. Because the pixel detector will contribute significantly to the ATLAS track and vertex reconstruction. The detector…

The main goals of the Absolute Luminosity For ATLAS (ALFA) detector is to provide an absolute luminosity and total cross section measurement. The measurement method used, the detector alignment and the quality of the collected data are…

A first measurement of the ttgamma cross section in pp collisions at the LHC using 1.04 fb^-1 of data taken with the ATLAS detector is presented. A total of 122 candidate events were identified in the single electron and single muon…

Charged-particle reconstruction is a fundamental part of the event reconstruction in modern multi-purpose high-energy physics detectors. This paper describes the algorithms used to reconstruct charged particles and primary vertices with the…

This paper presents the performance of an AC transmission switching (TS) based real-time contingency analysis (RTCA) tool that is introduced in Part I of this paper. The approach quickly proposes high quality corrective switching actions…

We present simulations of the production cross-section measurement of top-antitop pairs in the di-leptonic decay channel with the ATLAS detector. This study uses the Commissioning Service Challenge (CSC) data, which is the latest and…

The Monitored Drift Tube (MDT) chambers for the muon spectrometer of the AT- LAS detector at the Large Hadron Collider (LHC) consist of 3-4 layers of pressurized drift tubes on either side of a space frame carrying an optical monitoring…

Detailed measurements of the electron performance of the ATLAS detector at the LHC are reported, using decays of the Z, W and J/psi particles. Data collected in 2010 at sqrt(s)=7 TeV are used, corresponding to an integrated luminosity of…

New measurements from ATLAS at the LHC are presented on the total cross section at $\sqrt{s}=8$ TeV from elastic scattering using the ALFA sub-detector and on the inelastic cross section at $\sqrt{s}=13$ TeV using the MBTS sub-detector.

A prototype detector for Compton camera imaging is under development. A monolithic array of 19 channel Silicon drift detector with on-chip electronics is going to be used as a scatter detector for the prototype system. Custom designed…

The readout systems for the ATLAS silicon trackers and liquid argon calorimeters utilize vertical-cavity surface-emitting laser diodes to communicate between on and off detector readout components. A number of these VCSEL devices have…

Reliable network measurements are a fundamental component of networking research as they enable network analysis, system debugging, performance evaluation and optimization. In particular, decoding the LTE control channel would give access…

A number of modern millimeter, sub-millimeter, and far-infrared detectors are read out using superconducting microwave (1-10GHz) resonators. The main detector technologies are Transition Edge Sensors, read out using Microwave SQUID…