Related papers: Design and Simulation of a High Frequency High Pow…
A new instrument for high resolution imaging of fast-neutrons is presented here. It is designed for energy selective radiography in nanosecond-pulsed broad-energy (1 - 10 MeV) neutron beams. The device presented here is based on hydrogenous…
We present a design for a radio-frequency driver that leverages telecom amplifiers to achieve high power output and wide bandwidth. The design consists of two compact printed circuit boards (total area $< 255$ cm), which incorporate power…
Fluid Antenna System (FAS) is recognized as a promising technology for enhancing communication performance. In this context, we explored the potential of FAS-assisted wireless powered communication systems. Specifically, the transmitter,…
We present a two-dimensional electron heterostructure field effect device of simplistic design and ease of fabrication that displays high mobility electron transport. This is accomplished using a high efficacy contacting scheme and simple…
This letter studies a wireless-powered amplify-and-forward relaying system, where an energy-constrained relay node assists the information transmission from the source to the destination using the energy harvested from the source. We…
RF energy harvesting is a promising potential solution to provide convenient and perpetual energy supplies to low-power wireless sensor networks. In this paper, we investigate the energy harvesting performance of a wireless sensor node…
The construction of the 60-MeV proton linac has started as a low-energy front of the KEK/JAERI Joint Project for a high-intensity proton accelerator facility at KEK. The accelerating frequency is 324 MHz. Five UHF klystrons are used as an…
In this paper, we present a new power allocation scheme for a decode-and-forward (DF) relaying-enhanced cooperative wireless system. While both source and relay nodes may have limited traditional brown power supply or fixed green energy…
Wireless power transfer via a dielectric loaded multi-moded split cavity resonator (SCR) is proposed. Unlike conventional inductive resonant coupling, the scheme enables the control of both the real and imaginary parts of the transfer…
New high current accelerator facilities like proposed for HIDIF or ESS require a beam with a high brilliance. These beams can not be produced by a single pass rf-linac. The increase in brightness in such a driver linac is done by several…
Dielectric waveguide (DWG) interconnects frequently utilize multimode waveguides due to their low dispersion in the fundamental mode. However, these links are more vulnerable to cross-modal coupling that significantly impacts their overall…
We have successfully demonstrated electrical charging using the electromotive force (EMF) generated in a ferromagnetic metal (FM) film under ferromagnetic resonance (FMR). In the case of Ni80Fe20 films, electrical charge due to the EMF…
Highly energetic ultrashort electron bunches have the potential to reveal the ultrafast structural dynamics in relatively thicker in-liquid samples. However, direct current (DC) voltages higher than 100 kV are exponentially difficult to…
We report on the design and characterization of a high-power amplifier with an output power of 36.5 dBm for a frequency range of 50 MHz to 1000 MHz with a total gain of 40 dB. The amplifier is optimized for driving acousto-optic and…
Radio Frequency Identification (RFID) and implantable biomedical devices need efficient power and data transfer with very low profile antennas. We propose a low profile electrically small antenna for near-field wireless power and data…
Since the introduction of the radio-frequency (rf) photoinjector electron source over thirty years ago, peak performance demands have dictated the use of high accelerating electric fields. With recent strong advances in obtainable field…
The technological exploitation of ferroelectricity in CMOS electron devices offers new design opportunities, but also significant challenges from an integration, optimization and modelling perspective. We here revisit the working principle…
A simple and novel setup for high-frequency dielectric spectroscopy of materials has been developed using a portable vector network analyzer. The measurement principle is based on radio-frequency reflectometry, and both its capabilities and…
We demonstrate a microwave power-to-electrical energy conversion in a resonator-coupled double quantum dot. The system, operated as a photodiode, converts individual microwave photons to electrons tunneling through the double dot, resulting…
2D ferroelectric \{beta}-InSe/graphene heterostructure was fabricated by mechanical exfoliation, and the carrier dynamics crossing the heterostructure interface has been systematically investigated by Raman, photoluminescence and transient…