Related papers: An MT-Style Optical Package for Optical Data Trans…
An optical package of novel design has been developed for the ATLAS pixel detector. The package contains two VCSELs and one PIN diode to transmit and receive optical signals. The design is based on a simple connector-type concept and is…
The on-detector optical link of the ATLAS pixel detector contains radiation-hard receiver chips to decode bi-phase marked signals received on PIN arrays and data transmitter chips to drive VCSEL arrays. The components are mounted on hybrid…
A compact radiation-tolerant array optical transmitter module (ATx) is developed to provide data transmission up to 10Gbps per channel with 12 parallel channels for collider detector applications. The ATx integrates a Vertical Cavity…
We present the design and test results of the Miniature optical Transmitter (MTx) and Transceiver (MTRx) for the high luminosity LHC (HL-LHC) experiments. MTx and MTRx are Transmitter Optical Subassembly (TOSA) and Receiver Optical…
Multicore optical fibers and ribbons based on fiber arrays allow for massively parallel transmission of signals via spatially separated channels, thereby offering attractive bandwidth scaling with linearly increasing technical effort.…
Mode division multiplexing (MDM) in optical fibers enables multichannel capabilities for various applications, including data transmission, quantum networks, imaging, and sensing. However, MDM optical fiber systems, usually necessities…
We study the feasibility of fabricating an optical link for the SLHC ATLAS silicon tracker based on the current pixel optical link architecture. The electrical signals between the current pixel modules and the optical modules are…
As data rates for multi-gigabit serial interfaces within multi-node compute systems approach and exceed 10 Gigabits per second (Gbps), board-to-board and chip-to-chip optical signaling solutions become more attractive, particularly for…
We present new results on the optical link for the pixel detector of the ATLAS experiment. An optical package of novel design has been developed for the opto-link. The design is based on a simple connector-type concept and is made of…
The signals received from the optical receivers like as SiPM and PMT due to the collision of energetic particles with the scintillators attached to these optical receivers, are weak and fast. To measure the number of signals as well as…
This work describes the architecture and implementation of a high-data-rate, energy-efficient millimeter-wave (mm-wave) waveguide solution for integration inside an Integrated Circuit (IC) package. The complete waveguide solution (together…
The on-detector optical link of the ATLAS pixel detector contains radiation-hard receiver chips to decode bi-phase marked signals received on PIN arrays and data transmitter chips to drive VCSEL arrays. The components are mounted on hybrid…
Development of optical links with 850 nm multi-mode vertical-cavity surface-emitting lasers (VCSELs) has advanced to 25 Gbps in speed. For applications in high-energy experiments, the transceivers are required to be tolerant in radiation…
Vertically integrated (3D) combinations of sensors and electronics provide the ability to fabricate small, fine pitch pixels with very small total capacitance monolithically integrated with complex circuitry. The small capacitance, enabled…
The central institute of electronics (ZEA-2) in the Forschungszentrum Juelich (FZJ) has developed a system to scan the response of the photocathode of photomultiplier tubes (PMT). The PMT sits tight on a supporting structure, while a blue…
Visible Light Communication (VLC) is seen as a complementary wireless technology to Radio Frequency (RF). However, VLC is very sensitive to the signal blockage and suffers from shadowing due to the high directionality of the optical…
Integrating all optical components of an optical coherence tomography (OCT) device into a single chip is a non-trivial and a challenging job. The design and development of such a lab-on-a chip will be possible only via…
Industry is transitioning from manually monitored components and processes to data-driven solutions. At the heart of this transformation is predictive maintenance, which relies on simultaneous, real-time monitoring of key operational…
We have designed three ASICs for possible applications in the optical links of a new layer of pixel detector in the ATLAS experiment for the first phase of the LHC luminosity upgrade. The ASICs include a high-speed driver for the VCSEL, a…
Free space optical communication systems with extremely high detector sensitivities are attractive for various applications with low size, weight and power requirements. For these practical systems, integrated hardware elements with small…