Related papers: Scaling issues for AlGaN/GaN HEMTs: performance op…
We report on the demonstration of a deep sub-micron normally-off AlGaN/GaN HEMT with high on-current and high threshold voltage (VTH). The high-performance device was realized by utilizing a gate recess with length and depth of 200 nm and…
III-V heterostructure based high electron mobility transistors (HEMTs) offer superior performance as compared to CMOS silicon transistors owing to the high mobility in the 2D electron gas (2DEG) channel at the heterostructure interface.…
The characterization of deep levels in AlGaN/GaN heterostructures is one of the most important problems in GaN high electron mobility transistors (HEMTs) technology. This work reports on a technique for determination of deep level…
The effects of contact geometry and ideality on InGaAs and Si nano-scale n-channel FinFET performance are studied using a quantum-corrected semi-classical Monte Carlo method. Illustrative end, saddle/slot, and raised source/drain contacts…
In this work, quantum ballistic simulation study of a III-V tri-gate MOSFET has been presented. At the same time, effects of device parameter variation on ballistic, subthrshold and short channel performance is observed and presented. The…
We analyze the operation of the hot-electron FET bolometers with the graphene channels (GCs) and the gate barrier layers (BLs). Such bolometers use the thermionic emission of the hot electrons heated by incident modulated THz radiation. The…
We present a method to obtain quantitative profiles of surface state charge density and monitor its dynamics under various stress conditions in high electron mobility transistor (HEMT) devices. The method employs an optical spectroscopy of…
Scaling transistors' dimensions has been the thrust for the semiconductor industry in the last 4 decades. However, scaling channel lengths beyond 10 nm has become exceptionally challenging due to the direct tunneling between source and…
Various mesoscopic devices exploit electrostatic side gates for their operation. In this paper, we investigate how voltage-biasing of graphene side gates modulates the electrical transport characteristics of graphene channel. We explore…
In this work, we experimentally investigate the frequency limit of Hall effect sensor designs based on a 2 dimensional electron gas (2DEG) gallium arsenide/aluminum gallium arsenide (GaAs/AlGaAs) heterostructure. The frequency limit is…
We have studied the origin of switching (telegraph) noise at low temperature in lateral quantum structures defined electrostatically in GaAs/AlGaAs heterostructures by surface gates. The noise was measured by monitoring the conductance…
This paper addresses the question of whether a ``rigid molecule'' (one which does not deform in an external field) used as the conducting channel in a standard three-terminal MOSFET configuration can offer any performance advantage relative…
Path planning is an important component of au- tonomous mobile sensing systems. This paper studies upper and lower bounds of communication performance over Gaussian sen- sor networks, to drive power-distortion metrics for path planning…
We study the lateral tunneling through the gate-voltage-controlled barrier, which arises as a result of partial elimination of the donor layer of a heterostructure along a fine strip using an atomic force microscope, between edge channels…
Nanofabricated metal gate electrodes are commonly used to confine and control electrons in electrostatically defined quantum dots. However, these same gates impart strain-induced potential fluctuations that can potentially impair device…
We experimentally investigate the charge induction mechanism across gated, narrow, ballistic graphene devices with different degrees of edge disorder. By using magnetoconductance measurements as the probing technique, we demonstrate that…
We present a current and charge conserving theory for the low frequency admittance of a two-dimensional electron gas connected to ideal metallic contacts and subject to a quantizing magnetic field. In the framework of the edge-channel…
High performance InGaAs gate-all-around (GAA) nanowire MOSFETs with channel length (Lch) down to 20nm have been fabricated by integrating a higher-k LaAlO3-based gate stack with an equivalent oxide thickness of 1.2nm. It is found that…
In this work, AlGaN/GaN HEMTs with dual-layer SiNx stressors (composed of a low-stress layer and a high-stress layer) were investigated. The low-stress padding layer solved the surface damage problem caused during the deposition of the…
Heat generated in gallium nitride (GaN) high-electron-mobility transistors (HEMTs) is often concentrated in nanoscale regions and must dissipate through multiple heterostructures. However, the influence of non-uniform heat sources on the…