Related papers: Atom Chips: Fabrication and Thermal Properties
Amorphous silicon films prepared by electron beam evaporation have systematically and substantially greater atomic density for higher thickness, higher growth temperature, and slower deposition rate, reaching the density of crystalline Si…
A quantum network which consists of several components should ideally work on a single physical platform. Neutral alkali atoms have the potential to be very well suited for this purpose due to their electronic structure which involves long…
Amorphous metallic foams are prospective materials due to unique combination of their mechanical and energy-absorption properties. In the present work, atomistic dynamics simulations are performed under isobaric conditions with the pressure…
We investigate the optical detection of single atoms held in a microscopic atom trap close to a surface. Laser light is guided by optical fibers or optical micro-structures via the atom to a photo-detector. Our results suggest that with…
We adopt thick-film technology to produce ultra high vacuum compatible interfaces for electrical signals. These interfaces permit voltages of hundreds of Volts and currents of several Amperes and allow for very compact vacuum setups, useful…
Sufficiently large electric current applied to metallic nanostructures can bring them far out-of-equilibrium, resulting in non-Ohmic behaviors characterized by current-dependent resistance. We experimentally demonstrate a linear dependence…
We have achieved stimulated laser cooling of thermal rubidium atomic beams on a silicon chip. Following pre-collimation via a silicon microchannel array, we perform beam brightening via a blue-detuned optical molasses. Owing to the small…
Spray deposition and inkjet printing of various nanostructures are emerging complementary methods for creating conductive coatings on different substrates. In comparison to established deposition techniques like vacuum metal coating and…
Creating materials that do not exist in nature can lead to breakthroughs in science and technology. Magnetic skyrmions are topological excitations that have attracted great attention recently for their potential applications in low power,…
Despite several decades of development, microfluidics lacks a sealing material that can be readily fabricated, leak-tight under high liquid water pressure, stable over a long time, and vacuum compatible. In this paper, we report the…
A major challenge for quantum computers is the scalable simultaneous execution of quantum gates. One approach to address this in trapped ion quantum computers is the implementation of quantum gates based on static magnetic field gradients…
The simulations of field-evaporation processes for silicon atoms on various Si(001) surfaces are implemented using the first-principles calculations based on the real-space finite-difference method. We find that the atoms which locate on…
Flexible NbC nanocomposite thin films with carbon content ranging from 0 to 99 at.% were deposited at room temperature on Si (100) and polystyrene substrates by non-reactive magnetron sputtering from pure Nb and C targets without applying…
Niobium thin film nanostructures were fabricated using electron beam lithography and a liftoff process involving a four layer resist system. Wires having micrometres in length and below 200 nm in width were deposited on an insulating…
This article introduces a thin-film thermocouple temperature sensor with symmetrical electrode structure. It uses PI film as a flexible substrate. Cu film and CuNi film made by MEMS manufacturing process as positive and negative electrodes.…
We propose to apply atom-chip techniques to the trapping of a single atom in a circular Rydberg state. The small size of microfabricated structures will allow for trap geometries with microwave cut-off frequencies high enough to inhibit the…
Repeatable and reliable site-specific preparation of specimens for atom probe tomography (APT) at cryogenic temperatures has proven challenging. A generalized workflow is required for cryogenic-specimen preparation including lift-out via…
Atomic layer deposition was used to synthesize niobium silicide (NbSi) films with a 1:1 stoichiometry, using NbF5 and Si2H6 as precursors. The growth mechanism at 200oC was examined by in-situ quartz crystal microbalance (QCM) and…
A laser-cooled neutral-atom beam from a low-velocity intense source is split into two beams while guided by a magnetic-field potential. We generate our multimode-beamsplitter potential with two current-carrying wires on a glass substrate…
We use laser light shaped by a digital micro-mirror device to realize arbitrary optical dipole potentials for one-dimensional (1D) degenerate Bose gases of 87Rb trapped on an atom chip. Superposing optical and magnetic potentials combines…