Related papers: Very low shot noise in carbon nanotubes
We have measured shot noise in single walled carbon nanotubes (SWNT) with good contacts at 4.2 K at low frequencies ($f=600 - 850$ MHz). We find a strong modulation of shot noise over the Fabry-Perot pattern; in terms of differential Fano…
We report measurements on ropes of Single Walled Carbon Nanotubes (SWNT) in low-resistance contact to non-superconducting (normal) metallic pads, at low voltage and at temperatures down to 70 mK. In one sample, we find a two order of…
We study the low frequency current correlations of an individual single-walled carbon nanotube at liquid He temperature. We have distinguished two physical regimes -- zero dimensional quantum dot and one dimensional quantum wire -- in terms…
We have constructed a noise measurement setup for high impedance carbon nanotube samples. Our setup, working in the frequency range of 600 - 900 MHz, takes advantage of the fact that the shot noise power is reasonably large for high…
We have investigated shot noise in multiterminal, diffusive multiwalled carbon nanotubes (MWNTs) at 4.2 K over the frequency f = 600 - 850 MHz. Quantitative comparison of our data to semiclassical theory, based on non-equilibrium…
We have investigated shot noise in a 6-nm-diameter, semiconducting multiwalled carbon nanotube FET at 4.2 K over the frequency range 600 - 950 MHz. We find a transconductance of 3 - 3.5 $\mu$S for optimal positive and negative source-drain…
We have measured the electrical properties of individual bundles, or "ropes" of single-walled carbon nanotubes. Below ~10 K, the low bias conductance is suppressed for voltages below a few millivolts. In addition, dramatic peaks are…
Low-temperature measurements of asymmetric carbon nanotube (CNT) quantum dots are reported. The CNTs are end-contacted with one ferromagnetic and one normal-metal electrode. The measurements show a spin-dependent rectification of the…
We have investigated shot noise and conduction of graphene field effect nanoribbon devices at low temperature. By analyzing the exponential $I-V$ characteristics of our devices in the transport gap region, we found out that transport…
We report on shot noise measurements in carbon nanotube based Fabry-Perot electronic interferometers. As a consequence of quantum interferences, the noise power spectral density oscillates as a function of the voltage applied to the gate…
The high-bias electrical transport properties of suspended metallic single-walled carbon nanotubes (SWNTs) are investigated at various temperatures in vacuum, in various gases and when coated with molecular solids. It is revealed that…
We have altered the superconductivity of a suspended rope of single walled carbon nanotubes, by coating it with organic polymers. Upon coating, the normal state resistance of the rope changes by less than 20 percent. But superconductivity,…
The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…
The 1/f noise in individual semiconducting carbon nanotubes (s-CNT) in a field effect transistor configuration has been measured in ultra-high vacuum and following exposure to air. The amplitude of the normalized current spectral noise…
Recent experimental and theoretical results on intrinsic superconductivity in ropes of single-wall carbon nanotubes are reviewed and compared. We find strong experimental evidence for superconductivity when the distance between the normal…
Molecular level components, like carbon multiwalled nanotubes (MWNT), show great potential for future nanoelectronics. At low frequencies, only the outermost carbon layer determines the transport properties of the MWNT. Due to the…
We have observed the transversal vibration mode of suspended carbon nanotubes at millikelvin temperatures by measuring the single-electron tunneling current. The suspended nanotubes are actuated contact-free by the radio frequency electric…
We present theoretical study of shot noise in single wall metallic carbon nanotubes weakly coupled to either nonmagnetic or ferromagnetic leads. Using the real-time diagrammatic technique, we calculate the current, Fano factor and tunnel…
Building smaller transistors with enhanced functionality is critical in extending the limits of Moores law and meeting the demands of the electronics industry. Here we demonstrate transistor operation in a suspended single carbon nanotube…
We have carried out a preliminary analysis of shot noise at hopping, focusing on uniform 1D arrays of sites separated by N tunnel barriers. The results show that at low temperatures the low-frequency density of the shot noise varies from…