Related papers: Low noise cryogenic electronics: preamplifier conf…
Cryogenic phonon detectors with transition-edge sensors achieve the best sensitivity to light dark matter-nucleus scattering in current direct detection dark matter searches. In such devices, the temperature of the thermometer and the bias…
A microwave SQUID multiplexer ($\mu$MUX) has been optimized for coupling to large arrays of superconducting transition-edge sensor (TES) bolometers. We present the scalable cryogenic multiplexer chip design in a 1820-channel multiplexer…
Superconducting parametric amplifiers play a crucial role in the preparation and readout of quantum states at microwave frequencies, enabling high-fidelity measurements of superconducting qubits. Most existing implementations of these…
The fundamental limits of the microwave noise performance of high electron mobility transistors (HEMTs) are of scientific and practical interest for applications in radio astronomy and quantum computing. Self-heating at cryogenic…
This paper presents the design and benchmarking of cryogenic bulk-FETs using an experimentally calibrated TCAD framework that integrates 2-D electrostatics and interface-trap effects from $T = 2$ K to 300 K. For a 28-nm node device, carrier…
Graphene is an ideal material for hot-electron bolometers, due to its low heat capacity and weak electron-phonon coupling. Nanostructuring graphene with quantum dot constrictions yields detectors with extraordinarily high intrinsic…
Thermal-radiation detectors such as bolometers -- often found as thin, suspended films -- are intrinsically limited by their optical absorption properties and by their intrinsic thermal conductive and radiative losses. We analyze the impact…
We report on electron cooling power measurements in few-layer graphene excited by Joule heating by means of a new setup combining electrical and optical probes of the electron and phonon baths temperatures. At low bias, noise thermometry…
With a large portfolio of elemental quantum components, superconducting quantum circuits have contributed to dramatic advances in microwave quantum optics. Of these elements, quantum-limited parametric amplifiers have proven to be essential…
We have fabricated a wide-bandwidth, high dynamic range, low-noise cryogenic amplifier based on a superconducting kinetic inductance traveling-wave device. The device was made from NbTiN and consisted of a long, coplanar waveguide on a…
We proposed a new high resolution single photon infrared spectrometer for search for radiative decay of cosmic neutrino background(C$\nu$B). The superconducting-tunnel-junctions(STJs) are used as a single photoncounting device. Each STJ…
Impedance measurements provide a useful probe of the physics of bolometers and calorimeters. We describe a method for measuring the complex impedance of these devices. In previous work, stray impedances and readout electronics of the…
Precision instrumentation systems, such as optical receivers and other current-output measurement systems, often contain a transimpedance amplifier (TIA). The commonly used resistive feedback TIA (RF-TIA) has a drawback in its practical…
The future Ricochet experiment aims to search for new physics in the electroweak sector by measuring the Coherent Elastic Neutrino-Nucleus Scattering process from reactor antineutrinos with high precision down to the sub-100 eV nuclear…
Silicon-Germanium heterostructures are a promising quantum circuit platform, but crucial aspects as the long-term charge dynamics and cooldown-to-cooldown variations are still widely unexplored quantitatively. In this letter we present the…
The IR response of a backside illuminated type Yttrium Barium Copper Oxide (YBCO) transition-edge bolometer (TEB) in a free-membrane configuration is measured and analyzed. The analysis is based on a comprehensive equivalent circuit model…
We present a cryogenic microwave noise source with a characteristic impedance of 50 $\Omega$, which can be installed in a coaxial line of a cryostat. The bath temperature of the noise source is continuously variable between 0.1 K and 5 K…
We calculate the effects of doping nanostructuration and the patterning of thin films of high-temperature superconductors (HTS) with the aim of optimizing their functionality as sensing materials for resistive transition-edge bolometer…
The next generation of ultra-low-noise cryogenic detectors for space science applications require continued exploration of materials characteristics at low temperatures. The low noise and good energy sensitivity of current Transition Edge…
High-fidelity qubit measurement is a critical element of all quantum computing architectures. In superconducting systems, qubits are typically measured by probing a readout resonator with a weak microwave tone that must be amplified before…