Related papers: Tunable 300 W single-frequency 2 micron fiber ampl…
In this paper a CMOS two stage operational amplifier has been presented which operates at 1.8 V power supply at 0.18 micron (i.e., 180 nm) technology and whose input is depended on Bias Current. The op-amp provides a gain of 63dB and a…
A single tunable filter simplifies complexity, reduces insertion loss, and minimizes size compared to frequency switchable filter banks commonly used for radio frequency (RF) band selection. Magnetostatic wave (MSW) filters stand out for…
We demonstrate a high power, all-fiber, tunable laser source that can operate in the L-band region. A low power, tunable input laser is amplified with a recently proposed, high efficiency, 6th order cascaded Raman amplifier. The proposed…
An optical parametric chirped pulse amplifier fully based on Yb lasers at 500 kHz is described. Passive optical-synchronization is achieved between a fiber laser-pumped white-light and a 515 nm pump produced with a 200 W picosecond Yb:YAG…
We describe a tunable broadband mid-infrared laser source based on difference-frequency mixing of a 100 MHz femtosecond Yb:fiber laser oscillator and a Raman-shifted soliton generated with the same laser. The resulting light is tunable over…
High-power fiber laser amplifiers have enabled an increasing range of applications in industry, medicine and defense. The power scaling for narrow-band amplifiers is currently limited by the transverse modal instability. Various techniques…
We have built a parametric amplifier with a Josephson field effect transistor (JoFET) as the active element. The device's resonant frequency is field-effect tunable over a range of 2 GHz. The JoFET amplifier has 20 dB of gain, 4 MHz of…
The development of the sixth generation of wireless communications technology (6G) requires terminals that can operate at frequencies above 100 GHz. For human-centric applications, these terminals should also be flexible and have low power.…
Tunable biphotons are highly important for a wide range of quantum applications. For some applications, especially interesting are cases where two photons of a pair are far apart in frequency. Here, we report a tunable biphoton source based…
A near threshold all-optical backaction amplifier is realized. Operating near threshold in an integrated micronscale architecture allows a nearly three orders of magnitude improvement in both gain and optical power requirements over the…
An ultrafast laser based on coherent beam combination of four ytterbium-doped step-index fiber amplifiers is presented. The system delivers an average power of 3.5 kW and a pulse duration of 430 fs at 80 MHz repetition rate. The beam…
Nanometer scale power amplifiers (PA) at sub-THz suffer from severe parasitic effects that lead to experience limited maximum frequency and reduced power performance at the device transceiver front end. The integrated circuits researchers…
We report the amplification of an all-normal dispersion supercontinuum pulse in a Thulium / Holmium co-doped all-fiber chirped pulse amplification system. With a -20 dB bandwidth of more than 300 nm in the range 1800-2100 nm the system…
We describe a fiber Raman amplifier for nanosecond and sub-nanosecond pulses centered around 1260 nm. The amplification takes place inside a 4.5-m-long polarization-maintaining phosphorus-doped fiber, pumped at 1080 nm by 3-ns-long pulses…
Hybrid distributed Raman-EDFA amplifiers, with a continuous 91 nm gain bandwidth, are used to enable a record single mode fibre transmission capacity of 120.0 Tbit/s using 312x35 GBd DP-256QAM over 9x70 km spans.
Erbium-doped waveguide amplifiers have captured great attentions in recent years due to the rapid advance of photonic integration materials and fabrication techniques. In this work, a compact erbium-doped thin-film lithium niobate waveguide…
Kilowatt-level high efficiency all-fiberized Raman fiber amplifier based on pure passive fiber is proposed for the first time in this paper. The laser system is established on master oscillator power amplification configuration while a…
We present a hybrid fiber/waveguide design for a 100-MHz frequency comb that is fully self-referenced and temperature controlled with less than 5 W of electrical power. Self-referencing is achieved by supercontinuum generation in a silicon…
In the optical (380-700 nm) region, a simulation study was conducted to assess the low-signal gain, power conversion efficiency (PCE), and optical output power of a praseodymium-doped fiber optic amplifier (PDFA). The PDFA performance was…
High-power single-frequency fiber amplifiers are increasingly dominant in technologies that require high optical power, stability, and coherence simultaneously. In this chapter, we first provide an overview of their key characteristics,…