Related papers: A Wide-Input 0.25 um BCD LDO with Dual-Stage Ampli…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
Production cost minimization (PCM) simulation is commonly employed for assessing the operational efficiency, economic viability, and reliability, providing valuable insights for power system planning and operations. However, solving a PCM…
A novel linear blind adaptive receiver based on joint iterative optimization (JIO) and the constrained constant modulus (CCM) design criterion is proposed for interference suppression in direct-sequence ultra-wideband (DS-UWB) systems. The…
This paper investigates a reconfigurable intelligent surface (RIS)-aided wideband massive multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) system with low-resolution analog-to-digital converters…
We have developed a completely new type of general-purpose CCD data acquisition system which enables one to drive any type of CCD using any type of clocking mode. A CCD driver system widely used before consisted of an analog multiplexer…
A well-balanced detector with high sensitivity and low noise is presented in this paper. The two-stage amplification structure is used to increase electronic gain while keeping an effective bandwidth of about 70 MHz. In order to further…
In the past few years, advancements in the field of nano circuit design has become tougher than the demand. Low power devices have emerged tremendously.Both voltage mode aswell as current mode devices have proven alternative to each other…
Current radio frequency (RF) sensors at the Edge lack the computational resources to support practical, in-situ training for intelligent spectrum monitoring, and sensor data classification in general. We propose a solution via Deep Delay…
Software-Defined Networking (SDN) is increasingly adopted to secure Internet-of-Things (IoT) networks due to its centralized control and programmable forwarding. However, SDN-IoT defense is inherently a closed-loop control problem in which…
A family of interleaved current-fed high step-up dc-dc converters are introduced and analyzed here by combining a voltage multiplier (VM) and an active clamp circuit for high-voltage high-power applications. Low input currents and output…
Conventional hybrid analog-digital architectures for millimeter-wave massive multiple-input multiple-output (MIMO) systems suffer from poor scalability and high implementational costs. The former is caused by the high power loss in the…
A Rydberg superheterodyne sensing architecture is demonstrated in which a self-sustained oscillator (SSO) serves as a dynamically perturbed local oscillator (LO) for microwave detection. The SSO is realized by a phase-controlled…
This paper presents the analysis, design, fabrication, and measurement of an integrated low-noise amplifier (LNA) implemented using a 130 nm CMOS technology, operating in the 2.4 GHz band. The LNA is a crucial component in the performance…
This paper presents a low power, low jitter LC phase locked loop (PLL) which has been designed and fabricated in a commercial 0.25-um Silicon-on-Sapphire CMOS technology. Random jitter and deterministic jitter of the PLL are 1.3 ps and 7.5…
In this paper, large-scale intelligent reflecting sur-face (IRS)-assisted multiple-input single-output (MISO) system is considered in the presence of channel uncertainty. To maximize the average sum rate of the system by jointly optimizing…
Power electronic devices such as HVDC and FACTS can be used to improve the damping of poorly damped inter-area modes in large power systems. This involves the use of wide-area feedback signals, which are transmitted via communication…
Conventional boost converters are essential to connect low-voltage energy source such as battery with high voltage DC bus in Electric Vehicles due to its simple construction and high conversion efficiency. However, large output capacitor…
Analog-to-digital converters (ADCs) play a vital important role in any devices via manipulating analog signals in a digital manner. Given that the amplitude of the signal exceeds the dynamic range of the ADCs, clipping occurs and the…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
Ultra-reliable low-latency Vehicle-to-Everything (V2X) communications are needed to meet the extreme requirements of enhanced driving applications. Millimeter-Wave (24.25-52.6 GHz) or sub-THz (>100 GHz) V2X communications are a viable…