Related papers: A Practical Approach Towards Inertia Estimation Us…
Since transmission lines are crucial links in the power system, one line outage event may bring about interruption or even cascading failure of the power system. If a quick and accurate line outage detection and localization can be…
Inertial navigation systems (INS) are widely used in almost any operational environment, including aviation, marine, and land vehicles. Inertial measurements from accelerometers and gyroscopes allow the INS to estimate position, velocity,…
Synchrophasor data provide unprecedented opportunities for inferring power system dynamics, such as estimating voltage angles, frequencies, and accelerations along with power injection at all buses. Aligned to this goal, this work puts…
The use of phasor angle measurements provided by phasor measurement units (PMUs) in fault detection is regarded as a promising method in identifying locations of power line outages. However, communication errors or system malfunctions may…
The increasing deployment of distribution-level phasor measurement units (PMUs) calls for dynamic distribution state estimation (DDSE) approaches that tap into high-rate measurements to maintain a comprehensive view of the…
Real-time transient event identification is essential for power system situational awareness and protection. The increased penetration of Phasor Measurement Units (PMUs) enhance power system visualization and real time monitoring and…
In this paper, phasor measurement unit (PMU) placement for power grid state estimation under different degrees of observability is studied. Observability degree is the depth of the buses' reachability by the placed PMUs and thus constitutes…
Phasor measurement units (PMUs) provide accurate and high-fidelity measurements in order to monitor the state of the power grid and support various control and planning tasks. However, PMUs have a high installation cost prohibiting their…
The power system frequency is important for the system overall stability. However, there does not exist a single measurement point of the system frequency due to the distributed nature of the system inertia and the small inconsistency of…
In this paper, a novel linear formulation for power system state estimation that simultaneously treats conventional and synchrophasor measurements is proposed. A linear circuit model for conventional measurements is introduced to enable a…
Wide-area dynamic studies are of paramount importance to ensure the stability and reliability of power grids. The rising deployment synchrophasor and other sensing technologies has made data-driven modeling and analysis possible using the…
Phasor Measurement Unit (PMU) technology is increasingly used for real-time monitoring applications, especially line outage detection and identification (D&I) in the power system. Current outage D&I schemes either assume a full PMU…
Phasor measurement units (PMUs) have the advantage of providing direct measurements of power states. However, as the number of PMUs in a power system is limited, the traditional supervisory control and data acquisition (SCADA) system cannot…
This paper presents a trajectory tracking control strategy that modulates the active power injected by geographically distributed inverter-based resources to support transient stability. Each resource is independently controlled, and its…
Phasor Measurement Units (PMUs) are used in the measurement, control and protection of power grids. However, deploying PMUs at every bus in a power system is prohibitively expensive, necessitating partial PMU placement that can ensure…
Accurate inertia estimates and forecasts are crucial to support the system operation in future low-inertia power systems. A large literature on inertia estimation methods is available. This paper aims to provide an overview and…
This paper presents a new phasor measurement unit (PMU)-based wide-area damping control (WADC) method to suppress the critical inter-area modes of large-scale power systems. Modal participation factors, estimated by a practically model-free…
Power quality monitoring has become a vital need in modern power systems owing to the need for agile operation and troubleshooting scheme. On the other hand, the nature of load in modern power system is changing in many ways. Digital loads,…
A large-scale deployment of phasor measurement units (PMUs) that reveal the inherent physical laws of power systems from a data perspective enables an enhanced awareness of power system operation. However, the high-granularity and…
When power grids are heavily stressed with a bulk power transfer, it is useful to have a fast indication of the increased stress when multiple line outages occur. Reducing the bulk power transfer when the outages are severe could forestall…