Related papers: Phase selection and texturing in molybdenum oxide …
In recent years, excitation of surface phonon polaritons (SPhPs) in van der Waals materials received wide attention from the nanophotonics community. Alpha-phase Molybdenum trioxide ($\alpha$-MoO3), a naturally occurring biaxial hyperbolic…
Nanomaterials are prone to influence by chemical adsorption because of their large surface to volume ratios. This enables sensitive detection of adsorbed chemical species which, in turn, can tune the property of the host material. Recent…
We report on the influence of the chemical composition on the electronic properties of molybdenum oxynitrides thin films grown by reactive sputtering on Si (100) substrates at room temperature. The partial pressure of Ar was fixed at 90 %,…
Interface chemistry and defect formation in MoS2 thin films grown on single crystal substrates critically determine the electronic structure of MoS2 and thus can strongly modify material functionality relevant for many applications,…
The technological conditions of oxygen content variation in epitaxial La0.7Sr0.3MnO3-{\delta} films and the peculiarities of change of their transport characteristics were investigated. The films were grown onto single crystal SrTiO3…
In this work, we develop a rapid reactive vapor transport technique to efficiently utilize limited isotopically pure precursors, particularly gaseous 18O2, and synthesize mm-scale, high-quality crystals within few-minute growth durations.…
Epitaxial growth of \k{appa}-phase Ga2O3 thin films are investigated on c-plane sapphire, GaN- and AlNon-sapphire, and (100) oriented yttria stabilized zirconia (YSZ) substrates via metalorganic chemical vapor deposition (MOCVD). The…
We have investigated the structural and magnetic properties of BiFeO$_3$ (BFO) thin films grown over (100)-oriented Si substrates by rf magnetron sputtering in a new route under O$_2$ free low pressure Ar atmosphere. Single-phase BFO films…
The influence of the deposition pressure PO2 and substrate temperature TS during the growth of Bi2FeCrO6 thin films grown by pulsed laser deposition has been investigated. It is found that the high volatility of Bi makes the deposition very…
Al2O3 thin films have been deposited at substrate temperatures between 500{\deg}C to 600{\deg}C by reactive magnetron sputtering using an additional arbitrary substrate bias to tailor the energy distribution of the incident ions. The films…
Molybdenum disulfide (MoS$_2$) is a promising material for making two-dimensional crystals and flexible electronic and optoelectronic devices at the nanoscale. MoS$_2$ flakes can show high mobilities and have even been integrated in…
Thin films of Cu-W-O ternary compounds were fabricated via DC magnetron co-sputtering from Cu and W metallic targets under controlled oxygen partial pressures, followed by thermal annealing. Low-oxygen conditions favored the formation of a…
Homogeneous face-centered cubic (fcc) polycrystalline CoCrFeNi films were deposited at room temperature on (0001)alpha-Al2O3 (c-sapphire). Phase and morphological stability of 200 to 670 nm thick films were investigated between 973 K and…
Layered metal dichalcogenide materials are a family of semiconductors with a wide range of energy band gaps and properties, and potential to open up new areas of physics and technology applications. However, obtaining high crystal quality…
Molybdenum disulfide (MoS2) has emerged as a promising, cost-effective catalyst for hydrogen production via water splitting. We investigate the structural and electrocatalytic properties of MoS2 thin films deposited on different substrates…
The two-dimensional layer of molybdenum disulfide (MoS2) has recently attracted much interest due to its direct-gap property and potential applications in optoelectronics and energy harvesting. However, the synthetic approach to obtain high…
We explore the U-Ge phase diagram using thin film growth by co-deposition of U and Ge via d.c. magnetron sputtering. Using three different single crystal substrates - MgO, CaF$_2$ and SrTiO$_3$ - we have stabilised mixed phase films of…
The success of isolating small flakes of atomically thin layers through mechanical exfoliation has triggered enormous research interest in graphene and other two-dimensional materials. For device applications, however, controlled large-area…
Monolayer Molybdenum disulfide (MoS2), a two-dimensional crystal with a direct bandgap, is a promising candidate for 2D nanoelectronic devices complementing graphene. There have been recent attempts to produce MoS2 layers via chemical and…
Molybdenum disulfide (MoS2) is a promising 2D transition metal dichalcogenide (TMD) for optoelectronics and quantum technology applications, but faces challenges in scalable synthesis and defect engineering. Oxygen-assisted chemical vapor…