Related papers: Sensitivity adjustable in-line high-temperature se…
Uncooled InfraRed (IR) detectors have enabled the rapid growth of thermal imaging applications. These detectors are predominantly bolometers, where the heating of pixel from incoming IR radiation is read out as a resistance change. Another…
In this paper, a novel coarse-to-fine optical MEMS accelerometer based on the Fabry Perot (FP) interferometer is proposed. The mechanical structure consists of a proof mass that is suspended by four L-shaped springs. The deflection of the…
In this work, we study temperature sensing with finite-sized strongly correlated systems exhibiting quantum phase transitions. We use the quantum Fisher information (QFI) approach to quantify the sensitivity in the temperature estimation,…
Accurate direct measurements of far-field thermal infrared emission become increasingly important because conventional methods, relying on indirect assessments, such as reflectance/transmittance, are inaccurate or even unfeasible to…
Field-deployable integrated photonic devices co-packaged with electronics will enable important applications such as optical interconnects, quantum information processing, precision measurements, spectroscopy, and microwave generation.…
Interferometric detection of mirror displacements is intrinsically limited by laser shot noise. In practice, however, it is often limited by thermal noise. Here we report on an experiment performed at the liquid helium temperature to…
We characterize a Fabry-Perot microwave cavity designed for trapping atoms and molecules at the antinode of a microwave field. The cavity is fed from a waveguide through a small coupling hole. Focussing on the compact resonant modes of the…
We have directly observed broadband thermal noise in silica/tantala coatings in a high-sensitivity Fabry-Perot interferometer. Our result agrees well with the prediction based on indirect, ring-down measurements of coating mechanical loss,…
Brillouin microscopy is an emerging optical technique for probing mechanical properties with submicron resolution, offering fully non-contact, label-free operation. Despite its unique capabilities, broader adoption has been limited by slow…
We present the full implementation of a room-temperature gravitational wave bar detector equipped with an opto-mechanical readout. The mechanical vibrations are read by a Fabry--Perot interferometer whose length changes are compared with a…
A novel, to the best of our knowledge, ultralow-temperature luminescence thermometry strategy is proposed, based on a measurement of relative intensities of hyperfine components in the spectra of Ho$^{3+}$ ions doped into a crystal. A…
An approach is demonstrated for comparing the temperature of the upper atmosphere obtained by ground-based and satellite methods. A method for calibrating ground-based instruments (Fabry-Perot interferometer) based on the data obtained and…
We demonstrate fiber Fabry-Perot (FFP) cavities with concave mirrors that can be operated at cavity lengths as large as 1.5mm without significant deterioration of the finesse. This is achieved by using a laser dot machining technique to…
The micro-cavity is a promising sensor platform, any perturbation would disturb its linewidth, cause resonance shift or splitting. However, such sensing resolution is limited by the cavity's optical quality factor and mode volume. Here we…
Resistance thermometry provides a time-tested method for taking temperature measurements. However, fundamental limits to resistance-based approaches has produced considerable interest in developing photonic temperature sensors to leverage…
We present a method to engineer the frequency splitting of polarization eigenmodes in fiber Fabry-Perot (FFP) cavities. Using specific pattern of multiple CO$_2$ laser pulses, we machine paraboloidal micromirrors with controlled elliptical…
Despite the broadband nature of thermal light sources, optical spectroscopy over multiple spectral bands simultaneously remains challenging. Here, we demonstrate a practical Fourier transform infrared spectrometer (FTIR) that achieves…
Fiber-based optical microcavities exhibit high quality factor and low mode volume resonances that make them attractive for coupling light to individual atoms or other microscopic systems. Moreover, their low mass should lead to excellent…
Non-contact temperature sensors are widely used, often utilizing infrared light for temperature measurement. However, specific applications demand non-contact detection, particularly within closed containers containing fluids or gases,…
Platinum silicide Schottky diodes formed on films of polycrystalline Si doped by phosphorus are demonstrated to be efficient and manufacturable CMOS-compatible temperature sensors for microbolometer detectors of radiation. Thin-film…