Related papers: Improved Dual-Output Step-Down Soft-Switching Curr…
A novel variable dc-link voltage technique is proposed to reduce the traction losses for electrical drive applications. A 100-unit cascaded multilevel converter is developed to generate the variable dc-link voltage. Experimental measurement…
It is well-known that optimizing network topology by switching on and off transmission lines improves the efficiency of power delivery in electrical networks. In fact, the USA Energy Policy Act of 2005 (Section 1223) states that the U.S.…
We analyze a dual-port grid-forming (GFM) control for power systems containing ac and dc transmission, converter-interfaced generation and energy storage, and legacy generation. To operate such a system and provide standard services,…
The level crossing analog-to-digital converters are meant for the effective conversion of sparse signals by construction. In these converters, the bandwidth-power trade-off requires a re-design of the comparators which takes a lot of time…
Grid-connected power converters encounter significant stability challenges during weak grid faults, when conventional PI-based controllers exhibit an oscillatory response and poor fault-ride-through performance. This paper addresses this…
Switched-Capacitor Converters (SCC) suffer from a fundamental power loss deficiency which make their use in some applications prohibitive. The power loss is due to the inherent energy dissipation when SCC operate between or outside their…
The goal of this work is to minimize the energy dissipation of embedded controllers without jeopardizing the quality of control (QoC). Taking advantage of the dynamic voltage scaling (DVS) technology, this paper develops a performance-aware…
Artificial-intelligence (AI) workloads are driving rapid growth in data-center electricity use and rack power density, increasing demand for power-delivery systems that are efficient and robust to fast load transients. Conventional…
This study focuses on optimizing the design parameters of a Dual Active Bridge (DAB) converter for use in 350 kW DC fast chargers, emphasizing the balance between efficiency and cost. Addressing the observed gaps in existing high-power…
We consider a cell-free massive multiple-input multiple-output (CFmMIMO) network operating in dynamic time division duplex (DTDD). The switching point between the uplink (UL) and downlink (DL) data transmission phases can be adapted…
Efficient delivery of current from PCB to point-of-load (POL) is a primary concern in modern high-power high-density integrated systems. Traditionally, a 48 V power signal is converted to the low, POL voltage at the board and/or package…
This paper presents an algorithm that solves the AC power flow problem for balanced, three-phase transmission systems at steady state. The algorithm extends the "fixed-point power flow" algorithm in the literature to include transmission…
This paper proposes an electronic circuit simulator-based method to accelerate the power system transient simulation, where the modeling of a generic HVDC (High Voltage Direct Current) system is focused. The electronic circuit simulation…
This paper presents a comprehensive review of dielectric barrier discharge (DBD) power supply topologies, aiming to bridge the gap between DBD applications and power electronics design. Two key aspects are examined: the dependence of the…
A common configuration for a stand-alone PV power system may consist of three converters: a buck converter for the PV panelto charge the battery, a boost converter for the battery to discharge to the load and one for the load voltage…
The mathematical modeling of open-switch faults in two-level machine-side converters and the fault-tolerant current control of isotropic permanent-magnet synchronous generators are discussed. The proposed converter model is generic for any…
A new "model-free" control methodology is applied to a boost power converter. The properties of the boost converter allow to evaluate the performances of the model-free strategy in the case of switching nonlinear transfer functions,…
Integrating grid-forming converters (GFMCs) into grid-following converter (GFLC)-dominated power systems enhances the grid strength, but GFMCs' current-limiting characteristic triggers dynamic switching between constant voltage control…
Renewable energy source such as photovoltaic (PV) cell generates power from the sun light by converting solar power to electrical power with no moving parts and less maintenance. A single photovoltaic cell produces voltage of low level. In…
AC optimal transmission switching (AC-OTS) is a computationally challenging problem due to the nonconvexity and nonlinearity of AC power-flow (PF) equations coupled with a large number of binary variables. A computationally efficient…