Related papers: Digital LLRF system for TRIUMF ISIS buncher
This paper introduces a newly designed cavity tuner for superconducting radio-frequency (SRF) cavity. Aiming to overcome the drawbacks of traditional tuning systems, like the limited tuning range of piezoelectric tuner and the low-speed…
A new approach was developed for the design of front-end circuits for semiconductor radiation detectors. The readout scheme consists of a first stage made of only a few components located close to the detector, and of a remote second stage…
FLASH and the European XFEL are SASE-FEL user facilities, at which superconducting TESLA cavities are operated in a pulsed mode to accelerate long bunch-trains. Several cavities are powered by one klystron. While the low-level rf system is…
In some types of mass spectrometers, such as Time of Flight mass spectrometers (TOF-MSs), it is necessary to control pulsed beams of ions. This can be easily accomplished by applying a pulsed voltage to the pusher electrode while the…
Initial test results of an L-band multi-beam klystron with parameters relevant for ILC are presented. The chief distinction of this tube from MBKs already developed for ILC is its low operating voltage of 60 kV, a virtue that implies…
Incremental upgrades of the legacy low level RF (LLRF) equipment-50 years for the Los Alamos Neutron Science Center (LANSCE)-involves challenges and problems not seen with new and total replacement opportunities. The digital LLRF upgrade at…
The KEK Accelerator Test Facility (ATF) is a dedicated testbed for nanobeam technologies in support of the International Linear Collider (ILC). Stable pulsed operation requires synchronization of the facility timing system with the…
Next generation radio telescopes, such as the Square Kilometre Array (SKA) and Next Generation Very Large Array (ngVLA), require precise microwave frequency reference signals to be transmitted over fiber links to each dish to coherently…
We present two prototypes of a gigabit transceiver ASIC, GBCR1 and GBCR2, both designed in a 65-nm CMOS technology for the ATLAS Inner Tracker Pixel Detector readout upgrade. The first prototype, GBCR1, has four upstream receiver channels…
An LCL filter offers superior attenuation for high-frequency harmonics for three-phase grid-following inverters compared to LC and L filters. However, it also introduces an inherent resonance peak, which can lead to power quality issues or…
A novel quadrature Doppler Backscattering (DBS) system has been developed and optimized for the E-band (60-90GHz) frequency range using either O-mode or X-mode polarization in DIII-D plasmas. In general, DBS measures the amplitude of…
The wireless in-band full-duplex (IBFD) technology can in theory double the system capacity over the conventional frequency division duplex (FDD) or time-division duplex (TDD) alternatives. But the strong self-interference of the IBFD can…
This paper studies the detection performance of a multiple-input-multiple-output (MIMO) multifunction radio frequency (MFRF) system, which simultaneously supports radar, communication, and jamming. We show that the detection performance of…
This contribution focuses on phase-noise added during frequency conversion in low-level radio frequency (LLRF) control systems. The stability of beams' parameters in linear accelerators depends on the stability of amplitude and phase of the…
In astronomy, image slicer integral field units (IFUs) are often used in integral field spectrographs to simultaneously record spatial and spectral information. The majority of astronomical instruments, including integral field…
An interlock system has been designed for the Fermilab Cryo-module Test Stand (CMTS), a test bed for the cryomodules to be used in the upcoming Linac Coherent Light Source 2 (LCLS-II) project at SLAC. The interlock system features 8…
We present a control and measurement setup for superconducting qubits based on Xilinx 16-channel radio-frequency system-on-chip (RFSoC) device. The proposed setup consists of four parts: multiple RFSoC boards, a setup to synchronise every…
Frequency domain multiplexing (fMux) is an established technique for the readout of transition-edge sensor (TES) bolometers in millimeter-wavelength astrophysical instrumentation. In fMux, the signals from multiple detectors are read out on…
In-loop filtering (ILF) is a key technology in video coding standards to reduce artifacts and enhance visual quality. Recently, neural network-based ILF schemes have achieved remarkable coding gains, emerging as a powerful candidate for…
In integrated sensing and communication (ISAC) systems, the target of interest may \textit{intentionally disguise itself as an eavesdropper}, enabling it to intercept and tap into the communication data embedded in the ISAC waveform. The…