Related papers: Digital LLRF system for TRIUMF ISIS buncher

In this article, we describe the key features of the recently completed technical design for the International Linear Collider (ILC), a 200-500 GeV linear electron-positron collider (expandable to 1 TeV) that is based on 1.3 GHz…

First beam commissioning of SuperKEKB (Phase-1), which is an asymmetry double ring collider of 7-GeV electron and 4-GeV positron beams, which had started from February, has been successfully accomplished at the end of June 2016, and the…

It is important to improve the frequency tracking between the RF drive and the cavity field for the purpose of reducing longitudinal phase oscillations and increasing the effective accelerating voltage. And this is especially beneficial for…

BPM (Beam Position Measurement) system is one of the most important beam diagnostic instruments in accelerators. A fully digital BPM (DBPM) has been designed for SSRF (Shanghai Synchrotron Radiation Facility). As Analog-to-Digital Converter…

In most digital-to-time converter (DTC) based applications, apart from maintaining low integral non-linearity (INL), it is also required of the system to achieve a wide frequency translation range. To achieve this performance, we present a…

CW magnetrons, developed for industrial heaters, but driven by an injection-locking signal were suggested to power Superconducting RF (SRF) cavities due to higher efficiency and lower cost of generated RF power per Watt than traditionally…

This paper presents a novel method for laser frequency stabilisation in the Laser Interferometer Space Antenna (LISA) mission by locking a laser to two stable length references - the arms of the interferometer and an on-board optical…

The use of precision timing measurements will be a major tool at the HL-LHC, where it will be used to suppress pile-up and to search for long-lived particles. To control a reference clock with sub-picosecond accuracy, we have fabricated in…

Puncturing is a promising technique in 3GPP to multiplex Enhanced Mobile Broadband (eMBB) and Ultra-Reliable Low Latency Communications (URLLC) traffic on the same 5G New Radio (NR) air interface. The essence of puncturing is to transmit…

A 16-element, compact phased array transceiver is demonstrated at E-band (71-76 and 81-86GHz). A Weaver image selection architecture reduces the LO tuning range to 3GHz while covering the 10GHz band. The bidirectional and efficient…

The next generation of space-based mm-wave telescopes, such as JAXA's LiteBIRD mission, require focal planes with thousands of detectors in order to achieve their science goals. Digital frequency-domain multiplexing (dfmux) techniques allow…

Synchronous reference frame phase-looked loop (SRF-PLL) techniques are widely used for interfacing and control applications in the power systems and energy conversion at large. Since a PLL system synchronizes its output with an exogenous…

The need for wireless communication has driven the communication systems to high performance. However, the main bottleneck that affects the communication capability is the Fast Fourier Transform (FFT), which is the core of most modulators.…

In FEL (Free-Electron Laser) accelerators, LLRF (Low-Level Radiofrequency) systems usually deploy feedback or feedforward algorithms requiring precise microwave measurement. The slow drift of the clock allocation network of LLRF…

The electronics of the LUX-ZEPLIN (LZ) experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), consists of low-noise dual-gain amplifiers and a 100-MHz, 14-bit data acquisition…

The Kaos spectrometer is maintained by the A1 collaboration at the Mainz Microtron MAMI with a focus on the study of (e,e'K^+) coincidence reactions. For its electron-arm two vertical planes of fiber arrays, each comprising approximately 10…

This paper proposes and evaluates a novel architecture for a low-power Time-to-Digital Converter with high resolution, optimized for both integration in multichannel chips and high rate operation (40 Mconversion/s/channel). This converter…

The primary accelerator of DCLS (Dalian Coherent Light Source) operates at a repetition rate of 20 Hz now, and the beam is divided at the end of the linear accelera-tor through Kicker to make two 10 Hz beamlines work simultaneously. For the…

The International Linear Collider (ILC) is a 200-500 GeV center-of-mass high-luminosity linear electron-positron collider, based on 1.3 GHz superconducting radio-frequency (SCRF) accelerating cavities. The ILC has a total footprint of about…

A clock synchronizing circuit for repeaterless low swing interconnects is presented in this paper. The circuit uses a delay locked loop (DLL) to generate multiple phases of the clock, of which the one closest to the center of the eye is…