Related papers: Scaled indium oxide transistors fabricated using a…
Transistor is a three terminal semiconductor device normally used as an amplifier or as a switch. Here the alternating current (a.c) rectifying property of the transistor is considered. The ordinary silicon diode exhibits a voltage drop of…
The two-dimensional layer of molybdenum disulfide (MoS2) has recently attracted much interest due to its direct-gap property and potential applications in optoelectronics and energy harvesting. However, the synthetic approach to obtain high…
We report on the electrical characterisation of a series of thin chromium oxide films, grown by dc sputtering, to evaluate their suitability for use as on-chip resistors in nanoelectronics. By increasing the level of oxygen doping, the…
In this letter, it is shown that the existing scaling theories for chemically doped transistors cannot be applied to the novel class of electrically doped 2D transistors and the concept of equivalent oxide thickness (EOT) is not applicable…
Two-dimensional (2D) semiconducting transition metal dichalcogenides (TMDs) are good candidates for high-performance flexible electronics. However, most demonstrations of such flexible field-effect transistors (FETs) to date have been on…
If metal surfaces are exposed to sufficiently oxygen-rich environments, oxides start to form. Important steps in this process are the dissociative adsorption of oxygen at the surface, the incorporation of O atoms into the surface, the…
The transparent and conductive properties of indium tin oxide (ITO) thin films, make them an attractive coating for optically integrated ion traps. However, the relatively low transmittance for wavelengths $<$ 400 nm, high scattering and…
In 2D-semiconductor-based field-effect transistors and optoelectronic devices, metal-semiconductor junctions are one of the crucial factors determining device performance. The Fermi-level (FL) pinning effect, which commonly caused by…
Modular architectures are a promising route toward scalable superconducting quantum processors, but finite fabrication yield and the lack of high quality temporary interconnects impose fundamental limitations on system size. Here, we…
Ultrathin oxide semiconductors with sub-1-nm thickness are promising building blocks for ultrascaled field-effect transistor (FET) applications due to their resilience against short-channel effects, high air stability, and potential for…
The silicon/silicon dioxide (Si/SiO2) interface plays a crucial role in the performance, cost, and reliability of most modern microelectronic devices, from the basic transistor to flash memory, digital cameras, and solar cells. Today the…
Scalable, high-speed, small-footprint photonic switching platforms are essential for advancing optical communication. An effective optical switch must operate at high duty cycles with fast recovery times, while maintaining substantial…
The evolution with carrier concentration of the electrical properties of amorphous indium oxide (InO) thin films has been studied using electronic double layer transistor configurations. Carrier variations of up to 7 X 10^(14) carriers/cm^2…
Transparent conductive indium tin oxide (ITO) thin films, electrochemically intercalated with sodium or other cations, show tunable superconducting transitions with a maximum $T_c$ at 5 K. The transition temperature and the density of…
The conductivity of organic semiconductors is measured {\it in-situ} and continuously with a bottom contact configuration, as a function of film thickness at various gate voltages. The depletion layer thickness can be directly determined as…
This paper reports on an approach for fabrication of micro-channels with nanometer thickness achieved by optimization of UV lithography processes. Rectangular micro-channels with a staple edge are fabricated over the surface of a silicon…
Thin-film transistors (TFTs) represent a wide-spread tool to determine the charge-carrier mobility of materials. Mobilities and further transistor parameters like contact resistances are commonly extracted from the electrical…
Amorphous oxide semiconductors (AOSs) have recently gained attention as a promising channel material of back-end-of-line (BEOL)-compatible transistors for monolithic three-dimensional (3D) integrations. However, the degradation in device…
InAs nanowires have been actively explored as the channel material for high performance transistors owing to their high electron mobility and ease of ohmic metal contact formation. The catalytic growth of non-epitaxial InAs nanowires,…
Self-ordered nanotubular titania TiO2-NT with outer tube diameter of 45 nm are synthesized using the anodic oxidation of titanium foil. Four sets of memristors with 100 ${\mu}m$ diameter based on Ti/TiO2-NT/Au sandwich structures with an…