Related papers: Study of simulations of double graded InGaN solar …

We analysed self-consistently photoconversion efficiency of direct-gap A3B5 semicon-ductors based solar cells and optimised their main physical characteristics. Using gallium ar-senide (GaAs) as the example and new efficient optimization…

Effect of geometrical and structural parameters on the efficiency of the tandem solar cell based on the III-V nanowire array on silicon is studied by the means of coupled opto-electrical simulations. A close to realistic structure,…

Zinc-diffusion can induce multiple failures in the electrical performance of a multijunction solar cell. In this work, we show an important Zn-diffusion from the AlGaInP back-surface-field layer to the emitter of the GaInP top cell of an…

Nano-scaled metallic or dielectric structures may provide various ways to trap light into thin-film solar cells for improving the conversion efficiency. In most schemes, the textured active layers are involved into light trapping structures…

Multijunction solar cell design is guided by both the theoretical optimal bandgap combination as well as the realistic limitations to materials with these bandgaps. For instance, triple-junction III-V multijunction solar cells commonly use…

We present a model for simulating performance of 3D nano -coaxial and -hemispherical thin film solar cells. The material system considered in these simulations is hydrogenated amorphous silicon (a-Si:H), with solar cells fabricated in an…

Photogalvanic solar cells, the original dye based solar cell, have yet to fulfill their promise as a low fabrication cost, scalable energy conversion system. The efficient performance of photogalvanic cells relies on high dye solubility and…

A high photon to electricity conversion efficiency of 47.2082% was achieved by a novel combination of In0.51Ga0.49P, GaAs, In0.24Ga0.76As and In0.19Ga0.81Sb subcell layers in a quadruple junction solar cell design. The electronic bandgap of…

We report on the influence of the quantum well thickness on the effective band gap and conversion efficiency of In0.12Ga0.88N/GaN multiple quantum well solar cells. The band-to-band transition can be redshifted from 395 to 474 nm by…

A design tool was formulated for optimizing the efficiency of inorganic, thin-film, photovoltaic solar cells. The solar cell can have multiple semiconductor layers in addition to antireflection coatings, passivation layers, and buffer…

Ternary organic solar cells (TOSC) are currently under intensive investigation, recently reaching a record efficiency of 17.1%. The origin of the device open-circuit voltage (VOC), already a multifaceted issue in binary OSC, is even more…

Among silicon-based solar cells, heterojunction cells hold the world efficiency record. However, their market acceptance is hindered by an initial 0.5\% per year degradation of their open circuit voltage which doubles the overall cell…

We present investigations of the optical properties of stacked InGaN quantum dot layers and demonstrate their advantage over single quantum dot layer structures. Measurements were performed on structures containing a single layer with…

Attaining low resistivity AlGaN layers is the keystone to improve the efficiency of light emitting devices in the ultraviolet spectral range. Here, we present a microstructural analysis of Ge-doped AlGaN samples with Al mole fraction from…

In this article, we demonstrate the design and simulation of a highly-efficient n-CdS/p-CIGS/p+-CGS dual heterojunction solar cell. The simulation was performed using SCAPS-1D software with reported experimental physical parameters. The…

Metastable defects can decisively influence the diode factor and thus the efficiency of a solar cell. The diode factor is also influenced by the doping level and the recombination mechanisms in the solar cell. Here we quantify how the…

We demonstrate an improvement in the performance of organic photovoltaic (OPV) systems based on small molecules by ionic gating via controlled reversible n-doping of multi-wall carbon nanotube (MWCNT) coated on fullerenes ETL: C60 and C70.…

A coupled optoelectronic model was implemented along with the differential evolution algorithm to assess the efficacy of grading the bandgap of the CZTSSe layer for enhancing the power conversion efficiency of thin-film CZTSSe solar cells.…

Hot carrier solar cells aim to overcome the theoretical limit of single-junction photovoltaic devices by suppressing the thermalization of hot carriers and extracting them through energy selective contacts. Designing efficient hot carrier…

This study underscores the pivotal role of sodium (Na) supply in optimizing the optoelectronic properties of wide bandgap (~1.6 eV) Cu(In,Ga)S2 (CIGS) thin film absorbers for high efficiency solar cells. Our findings demonstrate that the…