Related papers: Characterization and Modeling of Self-Heating in N…
This study unveils a groundbreaking exploration of using semiconductor technology in quantum circuitry. Leveraging the unique operability of 45 nm CMOS technology at deep cryogenic temperatures (~ 300 mK), a novel quantum electronic circuit…
In this work we propose a channel backscattering model in which increased carrier temperature at the top of the potential energy barrier in the channel is taken into account. This model represents an extension of a previous model by the…
Large-scale cryogenic Input-Output (IO) infrastructure is a requirement for realising fault-tolerant quantum computing in solid-state modalities. Such IO scaling presents significant challenges in thermal modelling, hardware design and…
High quality low leakage SINIS devices made of Al-AlMn-Al layers were fabricated for energy dispersive single photon detection. Information on different heat flow channels was extracted from the measured dynamics of detector signals due to…
In the context of the ATHENA X-IFU Cryogenic AntiCoincidence Detector (CryoAC) development, we have studied the thermalization properties of a 2mm x 2mm SQUID chip. The chip is glued on a front-end PCB and operated on the cold stage of a…
We report on experiments performed in vacuum and at cryogenic temperatures on a tri-port nano-electro-mechanical (NEMS) device. One port is a very non-linear capacitive actuation, while the two others implement the magnetomotive scheme with…
The ability to control and measure the temperature of propagating microwave modes down to very low temperatures is indispensable for quantum information processing, and may open opportunities for studies of heat transport at the nanoscale,…
Cryogenic semiconductor detectors operated at temperatures below 100 mK are commonly used in particle physics experiments searching for dark matter. The largest such germanium and silicon detectors, with diameters of 100 mm and thickness of…
In this dissertation, thermal and electrical properties of aligned multiwall carbon nanotubes (MWNTs) prepared by thermal decomposition of hydrocarbons have been experimentally studied. The thesis consists of six chapters. Ch1 is an…
In this paper a commercial 28-nm FDSOI CMOS technology is characterized and modeled from room temperature down to 4.2 K. Here we explain the influence of incomplete ionization and interface traps on this technology starting from the…
We investigate a quadruple quantum dot setup that can be employed to sense the temperature of an electrically isolated remote target reservoir. Such a setup was conceived earlier by S\'anchez et. al. (New Journal of Physics, 19, 113040) as…
Cooling systems based on the caloric effects of ferroic materials show high potential for various cooling and heat-pumping applications due to their potentially high efficiencies and the lack of any environmentally hazardous refrigerants.…
We discuss what kind of quantum channels can enable thermalization processes. We show that in order to determine a system's temperature, a thermometer needs to dynamically gain information about the system's local Hamiltonian and not just…
Current and future experiments observing the cosmic microwave background require a detailed understanding of optical performance at cryogenic temperatures. Pre-deployment analysis of optics can be performed in custom-engineered cryogenic…
Radiation sensors based on the heating effect of the absorbed radiation are typically relatively simple to operate and flexible in terms of the input frequency. Consequently, they are widely applied, for example, in gas detection, security,…
Temperature imaging of nanoscale systems is a fundamental problem which has myriad potential technological applications. For example, nanoscopic cold spots can be used for spot cooling electronic components while hot spots could be used for…
We demonstrate a 36$\times$36 gate electrode crossbar that supports 648 narrow-channel field effect transistors (FET) for gate-defined quantum dots, with a quadratic increase in quantum dot count upon a linear increase in control lines. The…
We introduce a nanocalorimetric technique based on microsecond-pulsed heating (\mu s-PHnC) that enables high-sensitivity, quasi-isothermal heat capacity measurements on nanoscale samples. Such resolution is critical for exploring…
Current state-of-the-art superconducting microwave qubits are cooled to extremely low temperatures to avoid sources of decoherence. Higher qubit operating temperatures would significantly increase the cooling power available, which is…
In this laboratory-based study, a plate was designed, manufactured and then characterised thermally and dimensionally using a thermal imager. This plate comprised a range of known scratch, dent, thinning and pitting artefacts as mimics of…