Related papers: Pulsed discharge plasma for graphite exfoliation i…
We report the frictional response of few-layer graphene (FLG) flakes obtained by liquid phase exfoliation (LPE) of pristine graphite. To this end, we inkjet print FLG on bare and hexamethyldisilazane-terminated SiO2 substrates, producing…
Edge engineering is important for both fundamental research and applications as the device size decreases to nanometer scale. This is especially the case for graphene because a graphene edge shows totally different electronic properties…
Mechanical exfoliation is a widely used method to isolate high quality graphene layers from bulk graphite. In our recent experiments, some ordered microstructures, consisting of a periodic alternation of kinks and stripes, were observed in…
High density polyethylene surfaces were exposed to the atmospheric post-discharge of a radiofrequency plasma torch supplied in helium and oxygen. Dynamic water contact angle measurements were performed to evaluate changes in surface…
A comparative study of polytetrafluoroethylene (PTFE) surfaces treated by the post-discharge of He and He-O2 plasmas at atmospheric pressure is presented. The characterization of treated PTFE surfaces and the species involved in the surface…
We study the electromagnetic properties of a metamaterial consisting of polarizable (nano)particles and a single graphene sheet placed at the interface between two dielectrics. We show that the particle's polarizability is renormalized…
We demonstrate, for the first time, confinement of the orientation of micron-sized graphitic flakes to a well-defined plane. We orient and rotationally trap lipid-coated highly ordered pyrolytic graphite (HOPG) micro-flakes in aqueous…
This comment addresses several issues in the paper by Sepioni et al., where it is stated that the ferromagnetism in pristine highly oriented pyrolytic graphite (HOPG) reported by several groups in the previous years is most likely due to…
We present an experimental observation of non-linear up- and down-converted optical luminescence of graphene and thin graphite subject to picosecond infrared laser pulses. We show that the excitation yields to a high density electron-hole…
Precise control of tensile stress and intrinsic damping is crucial for the optimal design of nanomechanical systems for sensor applications and quantum optomechanics in particular. In this letter we study the in uence of oxygen plasma on…
Aging limits lithium-ion battery lifetime and must be understood to improve durability and performance, requiring a detailed understanding of how aging alters the availability of cyclable lithium and the integrity of active particles. In…
It is shown experimentally that the photodetachment yield of surplus electrons created by plasma-induced charging of non-conductive surfaces of dielectric materials depends on the initial surface charge density and do not correlate with the…
We investigate ablation experiments performed by laser-plasma-filament guided electrical discharges at high-voltages of up to 145 kV. The guiding was accomplished via fs-laser-generated plasma filaments across a gap of 201 mm of air onto…
High-quality nitrogen-doped graphene on nickel is prepared by exploiting both the catalytic properties of nickel and the solubility of nitrogen atoms into its bulk. Following the standard chemical vapor deposition procedure, a previously…
We report the near-edge x-ray absorption fine structure (NEXAFS) spectrum of a single layer of graphite (graphene) obtained by micromechanical cleavage of Highly Ordered Pyrolytic Graphite (HOPG) on a SiO2 substrate. We utilized a…
We demonstrate that it is possible to mechanically exfoliate graphene under ultra high vacuum conditions on the atomically well defined surface of single crystalline silicon. The flakes are several hundred nanometers in lateral size and…
The effect of pulsed laser polishing on rough niobium surfaces was investigated. We created different well-defined roughness profiles with standard emery papers and subsequently remelted random surface areas with a size of about 2x2 mm^2…
We present an extensive study on electrical spectroscopy of graphene ribbons and edges of highly oriented pyrolytic graphite (HOPG) using atomic force microscope (AFM). We have addressed in the present study two main issues, (1) How does…
The deposition of dielectric materials on graphene is one of the bottlenecks for unlocking the potential of graphene in electronic applications. In this paper we demonstrate the plasma enhanced atomic layer deposition of 10 nm thin high…
This thesis was focused on the surface modification with plasma discharge. Austenitic AISI 316L stainless steel sample was carburised under different experimental conditions and mechanical properties have been studied (thickness, lattice…