Related papers: Passivating Surface Defects and Reducing Interface…
Multijunction solar cells in a tandem configuration could further lower the costs of electricity if crystalline Si (c-Si) is used as bottom cell. However, for direct monolithic integration on c-Si, only a restricted number of top and bottom…
Inorganic CdTe and FeSi2-based solar cells have recently drawn a lot of attention because they offer superior thermal stability and good optoelectronic properties compared to conventional solar cells. In this work, a unique alternative…
The monolithic tandem integration of third-generation solar energy materials on silicon holds great promise for photoelectrochemistry and photovoltaics. However, this can be challenging when it involves high-temperature reactive processes,…
Solution-processed quantum dots (QDs) have a high potential for fabricating low cost, flexible and large-scale solar energy harvesting devices. It has recently been demonstrated that hybrid devices employing a single monovalent cation…
Lead-free tin-based perovskites are highly appealing for the next generation of solar cells due to their intriguing optoelectronic properties. However, the tendency of Sn2+ oxidation to Sn4+ in the tin-based perovskites induces serious film…
The transition to sustainable energy has accelerated research into perovskite solar cells (PSCs) as promising candidates for next-generation photovoltaics. Despite their remarkable efficiencies, the commercialization of PSCs is hindered by…
We report on the fabrication and optimization of semi-transparent antimony sulfide (Sb$_2$S$_3$) thin-film solar cells in a superstrate configuration, using RF magnetron sputtering of metallic antimony followed by post-deposition…
Cu based ternary chalcogenides are gathering attention for sustainable energy applications due to their reduced complexity compared to quaternary alternatives. We used drift diffusion modeling to evaluate the feasibility of photovoltaics…
We present evidence that band gap narrowing at the heterointerface may be a major cause of the large open circuit voltage deficit of Cu$_2$ZnSnS$_4$/CdS solar cells. Band gap narrowing is caused by surface states that extend the…
Previous studies of reverse-bias stability in perovskite solar cells have focused primarily on voltage controlled reverse-bias tests. Here we instead present an investigation of perovskite solar cell degradation under well-defined, constant…
GeSn alloys are metastable semiconductors that have been proposed as building blocks for silicon-integrated short-wave and mid-wave infrared photonic and sensing platforms. Exploiting these semiconductors requires, however, the control of…
Semi-transparent photovoltaic devices for building integrated applications have the potential to provide simultaneous power generation and natural light penetration. CuIn$_{1-x}$Ga$_x$Se$_2$ (CIGS) has been established as a mature…
Cu(In,Ga)Se2 based solar cells exceed power conversion efficiencies of 23 %. Yet, the fill factor of these solar cells, with best values around 80 %, is relatively low (Si reaches 84.9%) mostly due to diode factors greater than one.…
Charge transport layers (CTLs) are key components of diffusion controlled perovskite solar cells, however, they can induce additional non-radiative recombination pathways which limit the open circuit voltage (V_OC) of the cell. In order to…
A systematic survey and subsequent research have been made on MoTe2-based n-CdS/p-MoTe2/p+-CGS device in solar cell and photodetector field. The optimization has been established by altering the various properties of each constituent layer…
Non-fullerene acceptors based on perylenediimides (PDIs) have garnered significant interest as an alternative to fullerene acceptors in organic photovoltaics (OPVs), but their charge transport phenomena are not well understood, especially…
The limiting factor preventing kesterite (CZTSSe) thin film solar cell performance further improvement is the large open-circuit voltage deficit (Voc,def) issue, which is 0.345V for the current world record device with an efficiency of…
Perovskite solar cells (PSCs) continue to be the front runner technology among emerging photovoltaic devices in terms of power conversion efficiency and application versatility. However, not only the stability but also the understanding of…
Kesterite is a leading candidate among inorganic thin-film photovoltaic technologies, offering sustainable and environmentally friendly solutions without reliance on critical raw materials. This study investigates the performance of…
Poly(3,4-ethylenedioxythiophene):polystyrenesulfonate (PEDOT:PSS) has been widely used as a hole transport layer in perovskite solar cells (PSCs). However, the high interface defect density and energy level mismatch between PEDOT:PSS and…