Related papers: High-Power Near-Concentric Fabry-Perot Cavity for …
We describe the design, construction, and characterization of a medium-finesse Fabry-P\'erot cavity for simultaneous frequency stabilization of two lasers operating at 960 and 780 nm wavelengths, respectively. The lasers are applied in…
Low-energy electron microscopy (LEEM) taken as intensity-voltage (I-V) curves provides hyperspectral images of surfaces, which can be used to identify the surface type, but are difficult to analyze. Here, we demonstrate the use of an…
We present an approach to mitigate coating thermal noise in optical cavities by using multiple TEM spatial modes to readout and stabilize laser frequency. With optimal weightings we synthesize a wider sampling of the mirror surface,…
We report on the design, fabrication and characterization of silica microtoroid based cavity opto-electromechanical systems (COEMS). Electrodes patterned onto the microtoroid resonators allow for rapid capacitive tuning of the optical…
Cryo-electron microscopy (cryo-EM) has recently become a premier method for obtaining high-resolution structures of biological macromolecules. However, it is limited to biomolecular samples with low conformational heterogeneity, where all…
Physical models of Ge energy band structure and material loss were implemented in LASTIP(TM), a 2D simulation tool for edge emitting laser diodes. The model calculation is able to match experimental data available. Important design…
Fourier ptychographic microscopy (FPM) is a pivotal computational imaging technique that achieves phase and amplitude reconstruction with high resolution and wide field of view, using low numerical aperture objectives and LED array…
Multistage coupling of laser-wakefield accelerators is essential to overcome laser energy depletion for high-energy applications such as TeV level electron-positron colliders. Current staging schemes feed subsequent laser pulses into stages…
We give a simple introduction to the properties and use of ultrastable optical cavities, which are increasingly common in atomic and molecular physics laboratories for stabilizing the frequency of lasers to linewidths at the kHz level or…
We report a study of the microwave conductivity of electron-doped Pr$_{1.85}$Ce$_{0.15}$CuO$_{4-\delta}$ superconducting thin films using a cavity perturbation technique. The relative frequency shifts obtained for the samples placed at a…
Quantum materials exhibit phases such as superconductivity at low temperatures, yet imaging their phase transition dynamics with high spatial resolution remains challenging due to conventional tools' limitations - scanning tunneling…
We have developed a new technique for photothermal displacement spectroscopy that is potentially orders of magnitude more sensitive than conventional methods. We use a single Fabry-Perot resonator to enhance both the intensity of the pump…
Low-weight, passive, thermal-adaptive radiation technologies are needed to maintain an operable temperature for spacecraft while they experience various energy fluxes. In this study, we used a thin-film coating with the Fabry-Perot (FP)…
Phase reconstruction is important in transmission electron microscopy for structural studies. We describe electron Fourier ptychography and its application to phase reconstruction of both radiation-resistant and beam-sensitive materials. We…
Studying the electrical signals generated by living cells is key to understanding numerous biological phenomena. Electrochromic optical recording (ECORE) uses the electrochromism exhibited by certain materials to noninvasively measure these…
Next-generation cryogenic transmission electron microscopes (TEM) aim to achieve high-resolution imaging at ultracold sample temperatures (< 90 K) and over extended hold times. Lower temperatures enable atomic-scale characterization with…
Light in the mode of a Fabry-P\'erot cavity heats the mirror surfaces via optical absorption, causing thermoelastic deformation of the mirror substrates, which in turn dictates the shape of the mode. We develop an analytical model which…
Thin-film lithium niobate (TFLN) has played a pivotal role in the advancement of integrated photonics, by supporting a diverse range of applications including nonlinear optics, electro-optics, and piezo-optomechanics. The effective…
We demonstrate a micro-Fabry-P\'erot cavity array through laser etching of high-surface-quality mirrors onto a single fused silica substrate. A cavity finesse of $4750\pm 200$ was achieved with a simple array design with $500~\mu m$ cavity…
Modeling a single crystal of cuprate high-$T_c$ superconductor, such as $\rm{Bi_2Sr_2CaCu_2O_{8+\delta}}$, as a stack of intrinsic Josephson junctions, we formulate explicitly the cavity phenomenon of plasma oscillations and electromagnetic…