Related papers: Introduction of Sr into Bi2Se3 thin films by molec…
We report comprehensive x-ray diffraction studies of the crystal structure and epitaxy of thin films of the topological insulator Bi2Te3 grown on Si (1 1 1). The films are single crystals of high crystalline quality, which strongly depends…
We report a systematic study on the growth conditions of Sn$_{1-x}$In$_x$Te thin films by molecular beam epitaxy for maximization of superconducting transition temperature $T_\mathrm{c}$. Careful tuning of the flux ratios of Sn, In, and Te…
An archetypical layered topological insulator Bi$_2$Se$_3$ becomes superconductive upon doping with Sr, Nb or Cu. Superconducting properties of these materials in the presence of in-plane magnetic field demonstrate spontaneous symmetry…
Superconductivity at the interface of a heterostructure confined to nanometer-sized scale offers unique opportunities to study the exotic physics of two-dimensional superconductivity. The realization of superconductivity at the interface…
We report the growth of atomically smooth, single crystalline Bi2Se3 thin films on Si(111) by using molecular beam epitaxy. Scanning tunneling microscopy, low-energy electron diffraction, X-ray photoelectron emission spectroscopy and Raman…
The Cu-doped topological insulator Bi$_2$Se$_3$ has recently been found to undergo a superconducting transition upon cooling, raising the possibilities that it is the first known "topological superconductor" or realizes a novel non-Abelian…
We use first-principles simulations to investigate the topological properties of Bi$_2$Se$_3$ thin films deposited on amorphous SiO2, Bi$_2$Se$_3$/a-SiO$_2$, which is a promising substrate for topological insulator (TI) based device…
We report growth of superconducting Sr2RuO4 films by oxide molecular beam epitaxy (MBE). Careful tuning of the Ru flux with an electron beam evaporator enables us to optimize growth conditions including the Ru/Sr flux ratio and also to…
We investigated the Dirac-cone state and its modulation when an ultrathin film of topological insulator Bi2Se3 was epitaxially grown on a van-der-Waals ferromagnet Cr2Si2Te6 (CST) by angle-resolved photoemission spectroscopy. We observed a…
Quasi-two-dimensional layered BiSe, a natural super-lattice with Bi2Se3-Bi2-Bi2Se3 units, has recently been predicted to be a dual topological insulator, simultaneously weak topological insulator as well as topological crystalline…
High quality Bi2Te3 and Sb2Te3 topological insulators films were epitaxially grown on GaAs (111) substrate using solid source molecular beam epitaxy. Their growth and behavior on both vicinal and non-vicinal GaAs (111) substrates were…
Band structure engineering and interfacial buffer layers have been demonstrated as effective means to tune the Fermi level in topological insulators (TI). In particular, the charge compensated compound (BixSb1-x)2Te3 (BST) plays a critical…
The surface structure of the prototypical topological insulator Bi2Se3 is determined by low-energy electron diffraction and surface X-ray diffraction at room temperature. Both approaches show that the crystal is terminated by an intact…
We have studied the electron transport properties of topological insulator-related material Bi2Se3 near the superconducting Pb-Bi2Se3 interface, and found that a superconducting state is induced over an extended volume in Bi2Se3. This state…
Possible emergence of nematic superconductivity that breaks its underlying lattice symmetry in doped topological insulator Bi$_2$Se$_3$,establishes this system as a unique candidate of topological superconductors. Exclusion of possible…
Topological materials are derived from the interplay between symmetry and topology. Advances in topological band theories have led to the prediction that the antiperovskite oxide Sr$_3$SnO is a topological crystalline insulator, a new…
Recently, A2B3 type strong spin orbital coupling compounds such as Bi2Te3, Bi2Se3 and Sb2Te3 were theoretically predicated to be topological insulators and demonstrated through experimental efforts. The counterpart compound Sb2Se3 on the…
Mechanical exfoliation of bulk crystals has been widely used to obtain thin topological insulator (TI) flakes for device fabrication. However, such a process produces only micro-sized flakes that are highly irregular in shape and thickness.…
The tunability of the chemical potential for a wide range encompassing the Dirac point is important for many future devices based on topological insulators. Here we report a method to fabricate highly efficient top gates on epitaxially…
We investigate the complex relationship between the growth conditions and the structural and transport properties of $\mathrm{Ti_xO_y}$ thin films grown by molecular beam epitaxy. Transport properties ranging from metallicity to…