Related papers: Evaluation of gps/glonass patch versus rf gps (L1)…
This paper presents the analysis, design, fabrication, and measurement of an integrated low-noise amplifier (LNA) implemented using a 130 nm CMOS technology, operating in the 2.4 GHz band. The LNA is a crucial component in the performance…
When different radio applications share the same spectrum, the separation by attenuating material is a way to mitigate potential interference. The indoor restriction for WLAN devices in 5150-5350 MHz is an example for a regulatory measure…
New spectrum allocations in the 4--8 GHz FR1(C) and 7--24 GHz FR3 mid-band frequency spectrum are being considered for 5G/6G cellular deployments. This paper presents results from the world's first comprehensive indoor hotspot (InH)…
In this paper, design and simulation of a compact on-chip antenna for 60 GHz band applications is presented. Antenna is designed in 65nm TSMC technology. This technology consists of 9 metal layers. A 0.7 mm * 0.7 mm patch with slots is…
In this paper, we conduct wireless channel measurements in indoor corridor scenarios at 2.4, 5 and 6 GHz bands with bandwidth of 320 MHz. The measurement results of channel characteristics at different frequency bands such as average power…
This paper presents the design and implementation of a compact, cost-effective phased array antenna system. It is capable of real-time beam-steering for dynamic target-tracking applications. The system employs a 4$\times$4 rectangular…
In this contribution, we propose a GNSS/INS ultra-tight coupling in which the GNSS receiver architecture is based on a vector tracking loop type architecture. In the proposed approach, the phase lock loop bandwidth is adapted according to…
Reconfigurable Intelligent Surfaces (RIS) are known as a promising technology to improve the performance of wireless communication networks, and have been extensively studied. Movable Antennas (MA) are a novel technology that fully exploits…
In this paper, an outdoor channel measurement campaign at 330-360 GHz employing a 128 * 4 virtual antenna array (VAA)-based multiple-input multiple-output (MIMO) configuration is conducted. The transmitter (Tx) and receiver (Rx) location…
In this paper, we present new measurement results to model large-scale path loss, angular spread and channel sparsity at the sub-THz (141-145 GHz) band, for both indoor and outdoor scenarios. Extensive measurement campaigns have been…
This paper experimentally investigates geometry-based multi-antenna RF wireless power transfer (WPT) using a large-scale distributed indoor transmit array measuring 8 m by 4 m. Geometry-based beamforming uses known transmitter and receiver…
This paper presents an analytical framework for evaluating the coverage performance of the fluid antenna system (FAS)-enhanced LoRa wide-area networks (LoRaWANs). We investigate the effects of large-scale pathloss in LoRaWAN, small-scale…
This paper presents a global framework analysis of a microstrip antenna design circularly polarized with an operating frequency of 5.80 GHz and a bandwidth of at least 500 MHz. We evaluate the optimal antenna parameters to design…
This paper discusses the geometrical features and wideband performance of the beam with maximal ratio combining coefficients for a generic multi-antenna receiver. In particular, in case the channel is a linear combination of plane waves, we…
Generalized spatial modulation (GSM) uses $N$ antenna elements but fewer radio frequency (RF) chains ($R$) at the transmitter. Spatial modulation and spatial multiplexing are special cases of GSM with $R=1$ and $R=N$, respectively. In GSM,…
Millimeter wave technology being an emerging area is still very undeveloped. A substantial research needs to be done in this area as its applications are numerous. In the present endeavor, a rectangular patch antenna is designed on thick…
This work proposes a global navigation satellite system (GNSS) spoofing detection and classification technique for single antenna receivers. We formulate an optimization problem at the baseband correlator domain by using the Least Absolute…
Our long-term research goal is to model the in vivo wireless channel. As a first step towards this goal, in this paper we performed in vivo path loss measurements at 2.4GHz and make a comparison with free space path loss. We calculate the…
Radar cross section (RCS) reduction has become one of the critical research areas in recent years. The RCS of the target should be small to avoid detection. Different methods are used to reduce RCS, but the major challenge with many RCS…
In this paper, we propose a novel antenna architecture called movable antenna (MA) to improve the performance of wireless communication systems. Different from conventional fixed-position antennas (FPAs) that undergo random wireless channel…