Related papers: Analysis of Auto Zeroing Amplifier
This paper describes a 8 bits, 20 Msamples/s pipeline analog-to-digital converter implemented in 0.6 \mu m CMOS technology with a total power dissipation of 75.47 mW. Circuit techniques used include a precise comparator, operational…
We present a candidate sensor for future spectroscopic applications, such as a Stage-5 Spectroscopic Survey Experiment or the Habitable Worlds Observatory. This type of charge-coupled device (CCD) sensor features multiple in-line amplifiers…
In this paper, we consider the uplink channel estimation phase and downlink data transmission phase of cell-free millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems with low-capacity fronthaul links and…
The applications of automotive cameras in Advanced Driver-Assistance Systems (ADAS) are growing rapidly as automotive manufacturers strive to provide 360 degree protection for their customers. Vision systems must capture high quality images…
A four-stage operational transconductance amplifier (OTA) for ultra-low-power applications is introduced in this paper. The proposed circuit inclusive of frequency compensation requires minimal transistor count and passives, overcoming the…
We present a digitized adjoint method for realizing efficient inverse design of "digital" subwavelength nanophotonic devices. We design a single-mode 3-dB power divider and a dual-mode demultiplexer to demonstrate the digitized adjoint…
Cell-free massive MIMO has matured into a key candidate technology for 6G and beyond, owing to its ability to provide nearly uniform service quality to many user equipments (UEs) over the same time-frequency resources. Unlike conventional…
This paper presents a low-power 10-bit 130-MS/s successive approximation register (SAR) analog-to-digital converter (ADC) in 90 nm CMOS process. The proposed asynchronous ADC consists of a comparator, SAR logic block and two control blocks…
This paper suggests a practical "hybrid" synthesis methodology which integrates designer-derived analytical models for system-level description with simulation-based models at the circuit level. We show how to optimize stage-resolution to…
A new approach was developed for the design of front-end circuits for semiconductor radiation detectors. The readout scheme consists of a first stage made of only a few components located close to the detector, and of a remote second stage…
We report on the design and characterization of a high-power amplifier with an output power of 36.5 dBm for a frequency range of 50 MHz to 1000 MHz with a total gain of 40 dB. The amplifier is optimized for driving acousto-optic and…
This paper investigates the impact of technological constraints on passive elements in the design of inductively degenerated CMOS low-noise amplifiers (LNAs). A theoretical analysis is combined with circuit simulations in a 130-nm CMOS…
Current-steering digital-to-analog converter (DAC) is a prominent architecture that is commonly used in high-speed applications such as optical communications. One of the shortcomings of this architecture is the output glitches that are…
This article proposes a method for the measurement of Phase Noise (PN, or PM noise) and Amplitude Noise (AN, or AM noise) of Digital-to-Analog Converters (DAC) and Direct Digital Synthesizers (DDS) based on modulation-index amplification.…
This paper proposes a method to achieve zero voltage switching (ZVS) across the full duty cycle range in hybrid flying capacitor multilevel (FCML) converters, eliminating the need for dynamic level changing and active re-balancing.…
The self-noise of capacitive sensors, primarily caused by thermal noise from the gate-bias resistor in the preamplifier, imposes a fundamental limit on measurement sensitivity. In electret condenser microphones (ECMs), this resistor…
Current-steering (CS) digital-to-analog converters (DACs) generate analog signals by combining weighted current sources. Ideally, the current sources are combined at each switching instant simultaneously. However, this is not true in…
We develop a technique to overcome phase-mismatch in Josephson-junction traveling wave parametric amplifiers in order to achieve high gain over a broad bandwidth. Using "resonant phase matching," we design a compact superconducting device…
The upgrade of the ATLAS Liquid Argon Calorimeter readout system calls for the development of radiation tolerant, high speed and low power serializer ASIC. We have designed a phase locked loop using a commercial 0.25 um Silicon-on-Sapphire…
The circuit presented in this paper aims at providing three 40 Vpp 50Hz AC voltages sources with 120-degree phase separation between them. This is a fully analogue circuit that uses standard, low-cost electronic components without resorting…