Related papers: Influence of Ti$_3^+$ Defect-type on Heterogeneous…
Ferroelectricity in sputtered undoped-HfO$_2$ is attractive for composition control for low power and non-volatile memory and logic applications. Unlike doped HfO$_2$, evolution of ferroelectricity with annealing and film thickness effect…
Highly ordered TiO2 nanotube arrays (TNAs) codoped with V and N were synthesized by electrochemical anodization in association with hydrothermal treatment. The samples were characterized by field emission scanning electron microscopy, X-ray…
Low-dose nitrogen implantation induces in TiO2 nanotubes a co-catalytic activity for photocatalytic H2-evolution. The use of an ion implantation process leads to a N-implanted zone only at the top part of the tubes. The coupling of this top…
High-pressure torsion (HPT) can facilitate phase transformations in titanium dioxide (TiO2) and stabilize its high-pressure columbite phase, as an active photocatalyst, by shear straining under high pressure. This study aims to understand…
The use of trivalent erbium (Er$^{3+}$), typically embedded as an atomic defect in the solid-state, has widespread adoption as a dopant in telecommunications devices and shows promise as a spin-based quantum memory for quantum…
Thick anatase films were fabricated on graphite substrates using a method of anodic aqueous electrophoretic-deposition using oxalic acid as a dispersant. Thick films were subsequently fired in air and in nitrogen at a range of temperatures.…
Phase transition from anatase to rutile for the 70nm TiO2 crystallite has been investigated by annealing at different temperatures followed by TDPAC measurement of these TiO2 crystallites adsorbed with 181Hf tracer. The width of the peaks…
Knowledge of the molecular frontier levels' alignment in the ground state can be used to predict the photocatalytic activity of an interface. The position of the adsorbate's highest occupied molecular orbital (HOMO) levels relative to the…
Defects in the surface region of a reducible oxide, as TiO2, have a profound effect on applications, while their nature is very much influenced by the possibility of small polaron formation. Here, we probe rutile (110) and anatase (101)…
Interface of transition metal dichalcogenide (TMDC) and high-k dielectric transition metal oxides (TMO) had triggerred umpteen discourses due to the indubitable impact of TMO in reducing the contact resistances and restraining the…
Low-dimensional transition metal dichalcogenides (TMDC) exhibit great photocatalytic performance and tunability. In this work, using first-principles simulations based on density functional theory (DFT), we demonstrate that external…
Understanding how metal atoms are stabilized on metal oxide supports is important for predicting the stability of single-atom catalysts. In this study, we use scanning tunnelling microscopy (STM) and x-ray photoelectron spectroscopy (XPS)…
FePt/Fe3O4 nanoparticles can be used as building blocks to obtain, upon thermal annealing, magnetic nanocomposites with combined magnetic properties. Although the pre- and post-annealed samples are usually well characterized, a detailed…
We have investigated the properties of the $\beta$-Ga$_2$O$_3$($\bar201$)/HfO$_2$/Cr/Au MOS (metal-oxide-semiconductor) system after annealing (450$^\circ$C) in different ambient conditions (forming gas, N$_2$ and O$_2$). Defect properties…
We show that when TiO$_2$ anatase (001) is exposed to hydrogen plasma that the pristine surface termination becomes unfavorable to another, slightly modified, surface. On this modified surface the topmost TiO$_2$ layer is intact but out of…
Two-dimensional (2D) Janus transitional metal dichalcogenides (TMDCs) have great potential for photocatalytic water splitting due to their novel properties induced by the unique out-of-plane asymmetric structures. Here, we systematically…
Visible-light photocatalyst titanium dioxide (TiO2) was successfully prepared via a novel and facile single-mode microwave assisted synthesis process. In this one-step synthesis, Ti as target material selectively oxides in magnetic field…
Titanium dioxide (TiO2) is a key material in optoelectronic and energy conversion technologies, including solar cells and photocatalysis. However, integrating TiO2 into flexible or temperature-sensitive devices requires deposition…
Quantum photonic networks require two distinct functionalities: bright single-photon sources and long-lived quantum memories. III-V semiconductor quantum dots excel as deterministic and coherent photon emitters, while rare-earth ions such…
The optical properties of thermally annealed TiO2 samples depend on their preparation process, and the TiO2 thin films usually exist in the form of anatase or rutile or the mixture of the two phases. The electronic structures and optical…