Related papers: A simple method to prepare deuterated targets for …
A proton recoil method for measuring D-T neutron energy spectra using polyethylene film and Si (Au) surface barrier detector was presented. An iteration algorithm for unfolding the recoil proton energy spectrum to the neutron energy…
A compact cryogenic calibration target is presented that has a peak diffuse reflectance, $R \le 0.003$, from $800-4,800\,{\rm cm}^{-1}$ $(12-2\,\mu$m). Upon expanding the spectral range under consideration to $400-10,000\,{\rm cm}^{-1}$…
We present the results of our studies of deuterated molecules (DCN, DNC, DCO$^+$, N$_2$D$^+$ and NH$_2$D) in regions of high-mass star formation, which include a survey of such regions with the 20-m Onsala radio telescope and mapping of…
As a way to lower the cost of plastic scintillation detectors, commercially available polystyrene pellets have been used in the production of scintillating materials that can be extruded into different profiles. The selection of raw…
A metal-oxide film can be used as a hydrogen-isotope permeation barrier in the fuel circulation system for nuclear fusion. We fabricated Er$_2$O$_3$ thin film on a type 316L stainless-steel substrate by using a metal-organic chemical vapor…
This paper reports on the deposition of amorphous and crystalline thin films of Ga2O3 by reactive pulsed direct current magnetron sputtering from a liquid gallium target onto fused (f-) quartz and c plane (c-) sapphire substrates, where the…
We propose a low-pretension reflective kirigami film as a material for the reflective surfaces of large deployable space reflector antennas with an operating frequency around 10 GHz. The kirigami cut pattern is based on the well-known…
Thin films of phase pure pyrochlore Gd2Ti2O7 have been synthesized by RF magnetron sputtering. The films were prepared from oxide targets in 50%O2/Ar atmosphere and deposited on 111 YSZ substrates at a temperature of 800C. The pyrochlore…
A time-of-flight system with a plastic scintillator coupled to photomultipliers is developed for the external target facility (ETF). This system can satisfy the requirement of an ultrahigh vacuum ($\sim 10^{-9}$ mbar), a high counting rate…
The focusing of atoms interacting with both far-detuned and resonant standing wave fields in the thin lens regime is considered. The thin lens approximation is discussed quantitatively from a quantum perspective. Exact quantum expressions…
Studies of muonic atoms and muon catalyzed fusion have been conventionally done in a bulk target of gas, liquid or solid hydrogen isotopes. The use of thin film targets developed at TRIUMF have notable advantages in tackling some of the…
Deuteron-deuteron (DD) fusion reactions can be investigated at extremely low energies due to the relatively low Coulomb barrier that can be further reduced by the surrounding electrons in metallic targets. Recently, instead of an…
We describe the design, fabrication, and validation of a cryogenically-compatible quasioptical thermal source designed to be used for characterization of detector arrays. The source is constructed using a graphite-loaded epoxy mixture that…
Dewetting of thin metal films is one of the most widespread method for functional plasmonic nanostructures fabrication. However, simple thermal-induced dewetting does not allow to control degree of nanostructures order without additional…
A new method for directional fast neutron detection is proposed based on a neutron time projection chamber (TPC) and position-sensitive plastic scintillation detectors. The detection system can efficiently locate the approximate location of…
Atom probe tomography (APT) is extensively used to measure the local chemistry of materials. Site-specific preparation via a focused ion beam (FIB) is routinely implemented to fabricate needle-shaped specimens with an end radius in the…
Material deformation and failure under impact loading is a subject of active investigation in space science and often requires very specialized equipment for testing. In this work, we present the design, operational analysis and application…
We describe a very compact (0.9 m high, 0.4 m diameter, 40 kg) battery operable neutron scatter camera designed for field deployment. Unlike most other systems, the configuration of the sixteen liquid-scintillator detection cells are…
Epitaxial titanium diboride thin films have been deposited on sapphire substrates by Pulsed Laser Ablation technique. Structural properties of the films have been studied during the growth by Reflection High Energy Electron Diffraction…
A planar triplet of diffraction gratings is used to transform a single laser beam into a four-beam tetrahedral magneto-optical trap. This `flat' pyramid diffractor geometry is ideal for future microfabrication. We demonstrate the technique…