Related papers: CLICTD: A monolithic HR-CMOS sensor chip for the C…

The Compact Linear Collider (CLIC) is a proposed high-luminosity linear electron-positron collider at the energy frontier. It is foreseen to be built and operated in three stages, with a centre-of-mass energy ranging from a few hundred GeV…

The Drive Beam Linac of the Compact Linear Collider (CLIC) has to accelerate an electron beam with 4.2 A up to 2.4 GeV in almost fully-loaded structures. The pulse contains about 70000 bunches, one in every second rf bucket, and has a…

In the last years, high-resolution time tagging has emerged as the tool to tackle the problem of high-track density in the detectors of the next generation of experiments at particle colliders. Time resolutions below 50ps and event average…

The main methods grown Cadmium Zinc Telluride (CZT) crystals with high yield and excellent homogeneity are Modified Horizontal Bridgman (MHB) and High Pressure Bridgman (HPB) processes, respectively. In this contribution, the readout system…

We have developed a silicon nitride based photonic integrated circuit (PIC) that is responsible for the cooling, pumping and imaging of cold rubidium 87 atoms. The photonic integrated circuit consists of two chips placed next to each other…

The design, construction and performance of the H1 silicon vertex detector is described. It consists of two cylindrical layers of double sided, double metal silicon sensors read out by a custom designed analog pipeline chip. The analog…

We describe DSiD, a fast simulation Delphes detector for the International Linear Collider (ILC) based on the full simulation performance of the SiD detector. SiD is one of two detectors described in the ILC Technical Design Report (TDR).…

With an active silicon area of more than 200 squaremetres, the silicon strip tracker of the CMS experiment, one of the experiments currently under construction for the future Large Hadron Collider at CERN, will be by far the largest silicon…

The Compact Muon Solenoid (CMS) experiment at the Large Hadron Collider (LHC) is designed to study a wide range of high energy physics phenomena. It employs a large all-silicon tracker within a 3.8 T magnetic solenoid, which allows precise…

A study of 3D pixel sensors of cell size 50 {\mu}m x 50 {\mu}m fabricated at IMB-CNM using double-sided n-on-p 3D technology is presented. Sensors were bump-bonded to the ROC4SENS readout chip. For the first time in such a small-pitch…

We are investigating the feasibility of using CMOS foundries to fabricate silicon detectors, both for pixels and for large-area strip sensors. The availability of multi-layer routing will provide the freedom to optimize the sensor geometry…

Visible and near-infrared spectrum photonic integrated circuits are quickly becoming a key technology to address the scaling challenges in quantum information and biosensing. Thus far, integrated photonic platforms in this spectral range…

Recent advancements in particle physics demand pixel detectors that can withstand increased luminosity in the future collider experiments. In response, MALTA, a novel monolithic active pixel detector, has been developed with a cutting-edge…

Depleted Monolithic Active Pixel Sensors (DMAPS) constitute a promising low cost alternative for the outer layers of the ATLAS experiment Inner Tracker (ITk). Realizations in modern, high resistivity CMOS technologies enhance their…

The time resolution of the second monolithic silicon pixel prototype produced for the MONOLITH H2020 ERC Advanced project was studied using a femtosecond laser. The ASIC contains a matrix of hexagonal pixels with 100 {\mu}m pitch, readout…

We report recent results on the use of charge division to obtain a longitudinal coordinate from silicon strip detectors, and on sources of electronic readout noise for long, thin strips. These results hold promise for the design of Linear…

The goal of the TANGERINE project is to develop the next generation of monolithic silicon pixel detectors using a 65 nm CMOS imaging process, which offers a higher logic density and overall lower power consumption compared to previously…

In this study, we developed a new proton detector system called CATCH, which was designed for a scattering experiment involving a $\Sigma$ hyperon and a proton (J-PARC E40). CATCH is a cylindrical detector system covering an inner target…

The ALICE Inner Tracking System has been recently upgraded to a full silicon detector consisting entirely of MAPS, arranged in seven concentric layers around the LHC beam pipe. Further ahead, during the LHC Long Shutdown 3, the ALICE…

The Multi-Chip-Module-Deposited (MCM-D) technique has been used to build hybrid pixel detector assemblies. This paper summarises the results of an analysis of data obtained in a test beam campaign at CERN. Here, single chip hybrids made of…