Related papers: Artifacts and Errors in Cross-Spectrum Phase Noise…
Phase noise correction is crucial to exploit full advantage of orthogonal frequency division multiplexing (OFDM) in modern high-data-rate communications. OFDM channel estimation with simultaneous phase noise compensation has therefore drawn…
A number of popular measures of dependence between pairs of band-limited signals rely on analytic phase. A common misconception is that the dependence revealed by these measures must be specific to the spectral range of the filtered input…
A quantum two-path interferometer allows for direct measurement of the transmission phase shift of an electron, providing useful information on coherent scattering problems. In mesoscopic systems, however, the two-path interference is…
We investigate the effects of dichotomous noise added to a classical harmonic oscillator in the form of stochastic time-dependent gain and loss states, whose durations are sampled from two distinct exponential waiting time distributions.…
We present improved performance for a 92 to 96 GHz cross-spectrum phase modulated (PM) noise measurement system reported. The system is principally designed to measure amplifiers in pulsed mode as well as in CW mode at a given pulse…
The analysis of charge noise based on the Bloch-Redfield treatment of an ensemble of dissipative two-level fluctuators generally results in a violation of the fluctuation-dissipation theorem. The standard Markov approximation (when applied…
This paper reports the realization of a 5 MHz frequency difference x10 pre-multiplier, developed in the laboratory to replace an obsolete one. The principle we chose is to synthesize a 45 MHz and a 50 MHz from a reference signal and from…
During the On-Station Thermal Test campaign of the LISA Pathfinder the data and diagnostics subsystem was tested in nearly space conditions for the first time after integration in the satellite. The results showed the compliance of the…
Matter-wave interferometers utilizing different isotopes or chemical elements intrinsically have different sensitivities, and the analysis tools available until now are insufficient for accurately estimating the atomic phase difference…
A single electron transistor based on Al-AlO_x-Nb tunnel junctions was fabricated by shadow evaporation and in situ barrier formation. Its output current noise was measured, using a transimpedance amplifier setup, as a function of bias…
Fluctuations of the current through a tunnel junction are measured using a Josephson junction. The current noise adds to the bias current of the Josephson junction and affects its switching out of the supercurrent branch. The experiment is…
The close-in AM noise is often neglected, under the assumption that it is a minor problem as compared to phase noise. With the progress of technology and of experimental science, this assumption is no longer true. Yet, information in the…
This article addresses the measurement of the power spectrum of red noise processes at the lowest frequencies, where the minimum acquisition time is so long that it is impossible to average on a sequence of data record. Therefore, averaging…
Being complex-valued and low in signal-to-noise ratios, magnitude-based diffusion MRI is confounded by the noise-floor that falsely elevates signal magnitude and incurs bias to the commonly used diffusion indices, such as fractional…
We investigate synchronization in complex networks of noisy phase oscillators. We find that, while too weak a coupling is not sufficient for the whole system to synchronize, too strong a coupling induces a nontrivial type of phase slip…
The optoelectronic fiber delay line microwave oscillator offers attractive and large potential for numerous applications in high speed fiber optics communication, space, and radar systems. Its relevant features are very low phase noise and…
The phase lag between an applied forcing and a response to that forcing is a fundamen tal parameter in geophysical signal processing. For solid deforming materials, the phase lag between an oscillatory applied stress and the resulting…
The sliding mode observer is a useful method for estimating the system state and the unknown disturbance. However, the traditional single-layer observer might still suffer from high pulse when the output measurement is mixed with noise. To…
Noise-enhanced chaos in a doped, weakly coupled GaAs/Al_{0.45}Ga_{0.55}As superlattice has been observed at room temperature in experiments as well as in the results of the simulation of nonlinear transport based on a discrete tunneling…
Accurate phase estimation plays a pivotal role in quantum metrology, yet its precision is significantly affected by noise, particularly phase-diffusive noise caused by phase drift. To address this challenge, the joint estimation of phase…