Related papers: Inverted rear-heterojunction GaInP solar cells usi…
Solar cells are crucial for addressing global energy issues, with research focused on improving their efficiency. This study examines the impact of doping concentration gradients on solar cell performance. Doping involves adding impurities…
The p-type semiconductor Cu3PSe4 has recently been established to have a direct bandgap of 1.4 eV and an optical absorption spectrum similar to GaAs [Applied Physics Letters, 99, 181903 (2011)], suggesting a possible application as a solar…
A p-n junction maintained at above ambient temperature can work as a heat engine, converting some of the supplied heat into electricity and rejecting entropy by interband emission. Such thermoradiative cells have potential to harvest…
Few-layer selenium and tellurium films have been recently prepared, and they provide a new platform to explore novel properties of two-dimensional (2D) elemental materials. In this work, we have performed a systematic first-principles study…
The thermodynamic limit of photovoltaic efficiency for a single-junction solar cell can be readily predicted using the bandgap of the active light absorbing material. Such an approach overlooks the energy loss due to non-radiative…
All-perovskite tandem solar cells with narrow and wide bandgap perovskite absorbers are promising candidates for low-cost and high efficiency photovoltaic applications. However, the open circuit voltage of typical tandem structures is…
This paper proposes an efficient three-layered p-GaAs/p-CIGS/n-CdS (PPN), a unique solar cell architecture. Copper indium gallium selenide (CIGS)-based solar cells exhibit substantial performance than the ones utilizing cadmium sulfide…
We demonstrate a novel type of solar cell, one that uses fixed negative charges, formed at the interface of n-Si with Al2O3, to generate strong inversion at the Si surface by electrostatic repulsion. Built-in voltages of up to 755 mV are…
Despite the broadband response, limited optical absorption at a particular wavelength hinders the development of optoelectronics based on Dirac fermions. Heterostructures of graphene and various semiconductors have been explored for this…
The optical properties of V graded InGaN solar cells are studied. Graded InGaN well structures with the indium composition increasing then decreasing in a V shaped pattern have been designed. Through polarization doping, this naturally…
We have employed state-of-the-art cross-correlation noise spectroscopy to study carrier dynamics in silicon heterojunction solar cells, complimented by SENTARUS simulations of the same devices. These cells were composed of a light absorbing…
In this paper, we study band-to-band and intersubband characteristics of GaN/AlN heterostructures (planar and nanowires) structurally designed to absorb in the short-wavelength infrared region, particularly at 1.55 microns. We compare the…
High efficiencies of >30% are predicted for series-connected tandem solar cells when current-matching is achieved between the wide-bandgap top cell and silicon bottom cell. Sub-cells are typically optimised for current-matching based on the…
A spectral splitting, light trapping dielectric metasurface is designed, fabricated and integrated into a four-terminal perovskite/silicon hybrid tandem solar cell to increase the absorption of light close to the bandgap of the perovskite…
Tandem perovskite solar cells beckon as lower cost alternatives to conventional single junction solar cells, with all-perovskite tandem photovoltaic architectures showing power conversion efficiencies up to 26.4%. Solution-processing…
We present a comprehensive study of the electronic, magnetic, and optical properties of CuGa$_{1-x}$Fe$_x$S$_2$, as a promising candidate for intermediate-band (IB) solar cells. We use hybrid exchange-correlation functional within the…
The theoretical analysis of photovoltaic conversion efficiency of highly effective silicon solar cells (SC) is performed for n-type and p-type bases. The case is considered when the Shockley-Read-Hall recombination in the silicon bulk is…
We have demonstrated a high-performance low temperature solution processed electron selective contact consisting of 10 at% antimony doped tin oxide (ATO) and the neutral polymer polyethylenimine (PEI). Inverted organic photovoltaics (OPVs)…
Photoconductive devices based on ultra-wide-bandgap (UWBG) materials offer a promising pathway toward compact, high-voltage (HV) optoelectronic and optical sensing in harsh environments. In this Letter, we report field-tunable nonlinear…
This study underscores the pivotal role of sodium (Na) supply in optimizing the optoelectronic properties of wide bandgap (~1.6 eV) Cu(In,Ga)S2 (CIGS) thin film absorbers for high efficiency solar cells. Our findings demonstrate that the…