Related papers: A Time-to-Digital Converter-based Correction Metho…

Integrated photonics computing has emerged as a promising approach to overcome the limitations of electronic processors in the post-Moore era, capitalizing on the superiority of photonic systems. However, present integrated photonics…

We propose a novel digital-to-analog converter (DAC) weighting architecture that statistically minimizes the distortion caused by random timing mismatches among current sources. To decode the DAC input codewords into corresponding DAC…

In the last years, high-resolution time tagging has emerged as the tool to tackle the problem of high-track density in the detectors of the next generation of experiments at particle colliders. Time resolutions below 50ps and event average…

Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…

We study the calibration process in circular ultrasound tomography devices where the sensor positions deviate from the circumference of a perfect circle. This problem arises in a variety of applications in signal processing ranging from…

We present a concept to improve the spatial resolution of silicon pixel-detectors via the implementation of a sub-pixel cross-coupling, which introduces directional charge sharing between pixels. The charge-collection electrode is segmented…

The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…

The problem of measuring a time-varying phase, even when the statistics of the variation is known, is considerably harder than that of measuring a constant phase. In particular, the usual bounds on accuracy - such as the $1/(4\bar{n})$…

In this paper we present a novel method of atomic clock synchronisation combining digital error correction and phase tracking. Microwave broadcasts are used to measure the difference in frequency between a pair of atomic clocks. We use the…

Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…

Purpose: Current photon-counting computed tomography detectors are limited to a pixel size of around 0.3 mm-0.5 mm due to excessive charge sharing degrading the dose efficiency and energy resolution as the pixels become smaller. In this…

This paper describes an iterative method of per-pixel energy calibration of hybrid pixel detectors with GaAs:Cr sensor and Timepix readout chip. A convolution of precisely measured spectra of characteristic X-rays of different metals with…

We developed a high-speed and low-noise time-domain current measurement scheme using a homemade GaAs high-electron-mobility-transistor-based cryogenic transimpedance amplifier (TIA). The scheme is versatile for broad cryogenic current…

Timing-pick up detectors with excellent timing resolutions are essential in many modern nuclear physics experiments. Aiming to develop a Time-Of-Flight system with precision down to about 10 ps, we have made a systematic study of the timing…

Analog to digital conversion is a very important part of almost all beam instrumentation systems. Ideally, in a properly designed system, the used analog to digital converter (ADC) should not limit the system performance. However, despite…

We have designed, implemented and tested a time-to-digital converter core in a low-cost Spartan-6 FPGA. Our design exploits the finite propagation speed in carry chains to realize a delay line in which the propagation distance of the…

RF system-on-chip (RFSoC) devices provide the potential for implementing a complete radio astronomy receiver on a single board, but performance of the integrated analogue-to-digital converters is critical. We have evaluated the performance…

Analog to Digital Converters (ADCs) are a major contributor to the energy consumption on the receiver side of millimeter-wave multiple-input multiple-output (MIMO) systems with large antenna arrays. Consequently, there has been significant…

Current and next-generation particle tracking detectors will incorporate precision timing capabilities with resolutions approaching tens of picoseconds. Using Technology Computer-Aided Design (TCAD) simulations of Low-Gain Avalanche Diode…

This letter investigates the uplink of a multi-user millimeter wave (mmWave) system, where the base station (BS) is equipped with a massive multiple-input multiple-output (MIMO) array and resolution-adaptive analog-to-digital converters…