Related papers: A Time-to-Digital Converter-based Correction Metho…
An algorithm to measure the drift time of charge carriers in p-type point contact (PPC) high-purity germanium (HPGe) detectors from the signals processed with a charge-sensitive preamplifier is introduced. It is demonstrated that the drift…
Pipelined analog-to-digital converters (ADCs) are key enablers in many state-of-the-art signal processing systems with high sampling rates. In addition to high sampling rates, such systems often demand a high linearity. To meet these…
The static topological fractional charge (TFC) in condensed matter systems is related to the band topology and thus has potential applications in topological quantum computation. However, the experimental measurement of these TFCs in…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
Analog-to-digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) communication systems with large number of antennas. Use of low resolution ADCs has been proposed as a means to…
The paper considers the calibration of control-bounded analog-to-digital converters. It is demonstrated that variations of the analog frontend can be addressed by calibrating the digital estimation filter. In simulations (both behavioral…
- This paper describes a pipeline analog-to-digital converter is implemented for high speed camera. In the pipeline ADC design, prime factor is designing operational amplifier with high gain so ADC have been high speed. The other advantage…
The M\"ONCH hybrid pixel detector, with a 25 \textmu m pixel pitch and fast charge-integrating readout, has demonstrated subpixel resolution capabilities for X-ray imaging and deep learning-based electron localization in electron…
We present methods for efficient characterization of an optical coherent state $|\alpha\rangle$. We choose measurement settings adaptively and stochastically, based on data while it is collected. Our algorithm divides the estimation into…
With the new generation of the RPC, it is possible to work with induced signals of hundreds $\mu V$, hence the front-end electronics is an important and delicate part of the detector in order to get a detectable signal. The electronic chain…
We have developed a completely new type of general-purpose CCD data acquisition system which enables one to drive any type of CCD using any type of clocking mode. A CCD driver system widely used before consisted of an analog multiplexer…
It is known that the estimated energy consumption of digital-to analog converters (DACs) is around 30\% of the energy consumed by analog-to-digital converters (ADCs) keeping fixed the sampling rate and bit resolution. Assuming that…
A wideband phase comparator for precise measurements of phase difference of high current shunts has been developed at INRIM. The two-input digital phase detector is realized with a precision wideband digitizer connected through a pair of…
In the upcoming LHC Run 3, starting in 2021, the upgraded Time Projection Chamber (TPC) of the ALICE experiment will record minimum bias Pb-Pb collisions in a continuous readout mode at an interaction rate up to 50 kHz. This corresponds to…
Sensing electric fields with high sensitivity, high spatial resolution and at radio frequencies can be challenging to realize. Recently, point defects in silicon carbide have shown their ability to measure local electric fields by optical…
We demonstrate a point-to-point clock synchronization protocol based on bidirectionally exchanging photons produced in spontaneous parametric down conversion (SPDC). The technique exploits tight timing correlations between photon pairs to…
In this paper, we investigate the relationship between the dynamic range and quantization noise power in modulo analog-to-digital converters (ADCs). Two modulo ADC systems are considered: (1) a modulo ADC which outputs the folded samples…
In modern communication systems, the fidelity of analog-to-digital converters (ADCs) is limited by sampling clock jitter, i.e., small random timing deviations that undermine ideal sampling. Traditional scalar models often treat jitter as…
This work presents a fully-digital high-accuracy real-time calibration procedure for frequency and time alignment of open-loop wirelessly coordinated coherent distributed antenna array (CDA) modems, enabling radio frequency (RF) phase…
The inductive charging of electric vehicles requires specific measurement and calibration systems. In fact, the measurement of power on board involves DC signals, which are superimposed to a significant AC ripple up to or over 150 kHz,…