Related papers: A Time-to-Digital Converter-based Correction Metho…

This paper proposes a high-precision time measurement method based on digital frequency-domain phase-fitting (DFPF) by using the digitized nuclear pulses. The averaging effect inherent in the frequency-domain cross-correlation and…

This paper proposes and evaluates a novel architecture for a low-power Time-to-Digital Converter with high resolution, optimized for both integration in multichannel chips and high rate operation (40 Mconversion/s/channel). This converter…

Fully Field Programmable Gate Array (FPGA)based digitizer for high-resolution time and energy measurement is an attractive low cost solution for the readout electronics in positron emission computed tomography (PET)detector. In recent…

Conventional analog-to-digital converters (ADCs) fail to capture high-dynamic-range (HDR) signals due to clipping. Modulo ADCs circumvent this limitation by folding the input prior to quantization and algorithmically reconstructing the…

For TOF positron emission tomography (TOF PET) detectors, time-to-digital converters (TDCs) are essential to resolve the coincidence time of the photon pairs. Recently, an efficient TDC structure called ring-oscillator-based (RO-based)…

With today's increasing demand for digital devices in Substation Automation Systems (SAS) based on the IEC61850 standard, the measured data error due to the synchronization problem should be considered as a significant problem in…

Development of readout electronics for Time Projection Chamber for a Linear Collider is ongoing under stringent requirements on high channel density, lowest possible power consumption and small material budget. In the studied TPC readout…

Time and charge measurements over a large dynamic range from 1 Photo Electron (P.E.) to 4000 P.E. are required for the Water Cherenkov Detector Array (WCDA), which is one of the key components in the Large High Altitude Air Shower…

With the advent of the 5G wireless networks, achieving tens of gigabits per second throughputs and low, milliseconds, latency has become a reality. This level of performance will fuel numerous real-time applications, such as autonomy and…

This paper presents a low hardware consumption, resolution-configurable, automatically calibrating Gray code oscillator time-to-digital converter (TDC) in Xilinx 16nm UltraScale+, 20nm UltraScale and 28nm Virtex-7 field-programmable gate…

We present a Time-to-Digital Converter (TDC) implemented on a 16 nm Xilinx UltraScale Plus FPGA that achieves a resolution of 1.15 ps, RMS precision of 3.38 ps, a differential nonlinearity (DNL) of [-0.43, 0.24] LSB, and an integral…

A readout electronic with high time and energy resolution performance is designed for the SDD (Silicon Drift Detector) signals readout, which is aimed for X-ray pulsar based navigation (XNAV). For time measurement, the input signal is fed…

A fully digital beam position and phase measurement (BPPM) system was designed for the linear accelerator (LINAC) in Accelerator Driven Sub-critical System (ADS) in China. Phase information is obtained from the summed signals from four…

Obtaining digital representations of multivariate continuous-time (CT) signals is a challenge encountered in many signal processing systems. In practice, these signals are often acquired to extract some underlying information, i.e., for a…

Digital correlated double sampling (DCDS), a readout technique for charge-coupled devices (CCD), is gaining popularity in astronomical applications. By using an oversampling ADC and a digital filter, a DCDS system can achieve a better…

We propose a new digital-to-analog converter (DAC) for realizing a synapse circuit of mixed-signal spiking neural networks. We named this circuit "time-domain DAC (TDAC)". This produces weights for converting a digital input code into…

We present the design and test results of a Time-to-Digital-Converter (TDC). The TDC will be a part of the readout ASIC, called ETROC, to read out Low-Gain Avalanche Detectors (LGADs) for the CMS Endcap Timing Layer (ETL) of High-Luminosity…

Time-tagging units and coincidence detectors are used in many scientific research fields. The required timing resolution and number of input channels are varying, but some emerging experiments in the field of quantum optics require up to 32…

Data acquisition is an important process in the functioning of any control system. Usually, the acquired signal is analogic, representing a continuous physical measure, and it should be processed in a digital system based on an analog to…

In recent years, high speed and high resolution analog-to-digital converter (ADC) is widely employed in many physical experiments, especially in high precision time and charge measurement. The rapid increasing amount of digitized data…