Related papers: Novel high efficiency quadruple junction solar cel…
All-perovskite tandem solar cells with narrow and wide bandgap perovskite absorbers are promising candidates for low-cost and high efficiency photovoltaic applications. However, the open circuit voltage of typical tandem structures is…
The endeavor of the scientific community to maximize the possibility to harvest Sun irradiation for energy production is mainly devoted to the improvement of the power conversion efficiency of devices and to the extension of the spectral…
Thermophotovoltaics are promising solid-state energy converters for a variety of applications such as grid-scale energy storage, concentrating solar-thermal power, and waste heat recovery. Here, we report the design, fabrication, and…
We obtain theoretical expressions for the photocurrent in the Heterojunction solar cells with Intrinsic Thin layer (HIT cells). Our calculations take into account tunneling of electrons and holes through wide-bandgap layers of $\alpha$-Si:H…
Two-step photon upconversion solar cells (TPU-SCs) belong to the class of solar cells that in principle can exceed the Shockley--Queisser limit for single-junction solar cells. A TPU-SC basically consists of a wide-gap and a narrow-gap…
CdTe-based thin film solar cell has been modeled and enumerated with a thin CuInTe2 (CIT) current booster layer. CdTe-based n-CdS/p-CdTe/p+-CIT/p++-WSe2 heterojunction device has been evaluated for the highest performance. It is revealed…
Choosing the Indium Gallium Nitride (InGaN) ternary alloy for thin films solar cells might yield high benefits concerning efficiency and reliability, because its bandgap can be tuned through the Indium composition and radiations have little…
Wide-gap Cu(In,Ga)S2 solar cells with In2O3:Sn (ITO) as transparent back contact are evaluated for the application as top cells in tandem devices. The effect of Na on the solar cell performance is investigated by supplying additional Na by…
We report thin-film InAs/GaAs quantum dot (QD) solar cells with $n-i-p{+}$ deep junction structure and planar back reflector fabricated by epitaxial lift-off (ELO) of full 3-inch wafers. External quantum efficiency measurements demonstrate…
We propose a new concept for the design of high-efficiency photocells based on ultra-thin (submicron) semiconductor films of controlled thickness. Using a microscopic model of a thin dielectric layer interacting with incident…
Sulphurization processes in Cu(In,Ga)Se$_2$ thin-film solar cells has been intensively studied in the last decade as a viable alternative to the existing Ga-grading. The main advantage of using S grading is that by substituting Se with S we…
The GaAs/AlGaAs materials system is well suited to multi-bandgap applications such as the multiple quantum well solar cell. GaAs quantum wells are inserted in the undoped AlGaAs active region of a pin structure to extend the absorption…
Quantum dot solar cells (QDSC) are widely acknowledged to be one of the best solar energy harvesting devices in the present world. Absorber layer is a core component of a QDSC with a strong influence on its operational efficiency. Hence, we…
Thin film solar cells have been attractive for decades in advanced green technology platforms due to its possibilities to be integrated with buildings and on-chip applications. However, the bottleneck issues involved to consider the current…
Photogalvanic solar cells, the original dye based solar cell, have yet to fulfill their promise as a low fabrication cost, scalable energy conversion system. The efficient performance of photogalvanic cells relies on high dye solubility and…
We derive the photovoltaic conversion efficiency limit for two-terminal tandem solar cells with a perovskite top cell and silicon bottom cell with an embedded spectrum splitter. For large-bandgap top-cells a spectrum splitter strongly…
In this article, we theoretically demonstrate multilevel impurity photovoltaic effect in an efficient silicon dual-homojunction solar cell that ensures an extended absorption of longer wavelength light. Along with suitable contact work…
We demonstrate single layer graphene/n-Si Schottky junction solar cells that under AM1.5 illumination exhibit a power conversion efficiency (PCE) of 8.6%. This performance, achieved by doping the graphene with…
Solar cells based on a light absorbing layer of the organometal halide perovskite CH$_3$NH$_3$PbI$_3$ have recently reached 15% conversion efficiency, though how these materials work remains largely unknown. We analyse the electronic…
Electric coupling between subcells of a monolithically grown multijunction solar cell in short circuit allows their simultaneous and independent characterization by means of photo- and electroreflectance. The photovoltage generated by…