Related papers: Novel High Efficiency Quadruple Junction Solar Cel…
High efficiencies of >30% are predicted for series-connected tandem solar cells when current-matching is achieved between the wide-bandgap top cell and silicon bottom cell. Sub-cells are typically optimised for current-matching based on the…
The growth of heavily doped tunnel junctions in inverted metamorphic multijunction solar cells induces a strong diffusion of Zn via a point-defects-assisted mechanism. The redistribution of Zn can compensate the n-type doping in the emitter…
In this article, we demonstrate the design and simulation of a highly-efficient n-CdS/p-CIGS/p+-CGS dual heterojunction solar cell. The simulation was performed using SCAPS-1D software with reported experimental physical parameters. The…
Maximum efficiency of ideal single-junction photovoltaic (PV) cells is limited to 33% (for one sun illumination) by intrinsic losses such as band edge thermalization, radiative recombination, and inability to absorb below-bandgap photons.…
Perovskite semiconductors have demonstrated outstanding external luminescence quantum yields, enabling high power conversion efficiencies (PCE). However, the precise conditions to advance to an efficiency regime above monocrystalline…
Organic-inorganic halide perovskite materials have emerged as attractive alternatives to conventional solar cell building blocks. Their high light absorption coefficients and long diffusion lengths suggest high power conversion efficiencies…
Photovoltaic materials facilitate the conversion of sunlight into electricity by harnessing the interaction between light and matter, offering an eco-friendly and cost-efficient energy solution. Combining data-driven approaches with static…
Improving the conversion efficiency of solar energy to electricity is most important to mankind. For single-junction photovoltaic solar-cells, the Shockley-Queisser thermodynamic efficiency limit is extensively due to the heat dissipation,…
Power-conversion efficiency is a critical factor for the wider adoption of solar-cell modules. Thin-film solar cells are cheap and easy to manufacture, but their efficiencies are low compared to crystalline-silicon solar cells and need to…
Tandem solar cells can better harness the energy of the solar spectrum. Chalcopyrite solar cells have drawn attention, being the only highly efficient devices with bandgap around 1.0 eV, suitable for bottom cells. In the quest for better…
We demonstrate four and two-terminal perovskite-perovskite tandem solar cells with ideally matched bandgaps. We develop an infrared absorbing 1.2eV bandgap perovskite, $FA_{0.75}Cs_{0.25}Sn_{0.5}Pb_{0.5}I_3$, that can deliver 14.8 %…
The ideal band gap for a photovoltaic active layer for the solar spectrum is around 1.3 eV. However oxides with such values are rare. One of the most studied oxides to date as a photovoltaic active layer is the cuprous oxide Cu2O. Its band…
We develop a new approach to calculate the obtainable limit of photoconversion efficiency of tandem solar cells (SCs) and applied it to SCs with both vertical and lateral designs at AM0 and AM1.5 conditions. To get the maximum efficiency,…
Numerical simulation of a solar cell can provide various information that can be useful to maximize its power conversion efficiency (PCE). In that respect we carried out a set of numerical simulation using AFORS-HET simulation program.…
Light fusion increases the efficiency of solar cells by converting photons with lower energy than the bandgap into higher energy photons. The solar cell converts the product photons to current. We use Monte Carlo simulation to predict that…
The efficiency of GaAs nanowire solar cells can be significantly improved without any new processing steps or material requirements. We report coupled optoelectronic simulations of a GaAs nanowire (NW) solar cell with vertical p-i-n…
The p-type amorphous/ n-type crystalline silicon (P+ a-Si/N+ c-Si) heterojunction was simulated for developing the solar cells with high conversion efficiency and low cost. The characteristic of such cells with different work function of…
Photovoltaic cells (PVc), as an energy provider to the next generation and the biggest source of renewable energy. Since the last decade improving efficiency and reducing the cost of PVc has been a subject of active research among…
We report thin-film InAs/GaAs quantum dot (QD) solar cells with $n-i-p{+}$ deep junction structure and planar back reflector fabricated by epitaxial lift-off (ELO) of full 3-inch wafers. External quantum efficiency measurements demonstrate…
Effect of geometrical and structural parameters on the efficiency of the tandem solar cell based on the III-V nanowire array on silicon is studied by the means of coupled opto-electrical simulations. A close to realistic structure,…