Related papers: An Advanced NCRF Linac Concept for a High Energy e…

Travelling wave (TW) disk-loaded accelerating structure is one of the key components in normal conducting (NC) linear accelerators, and has been studied for many years. In the design process, usually after the dimensions of each cell and…

We discuss a concept of a lower-energy version of the Large Hadron-electron Collider (LHeC), delivering electron-hadron collisions concurrently to the hadron-hadron collisions at the high-luminosity LHC at CERN. Assuming the use of a 20 GeV…

We discuss the new layout of a cavity chain (superstructure) allowing, we hope, significant cost reduction of the RF system of both linacs of the TESLA linear collider. The proposed scheme increases the fill factor and thus makes an…

CERN has recently launched the Future Circular Collider (FCC) study to deal with all aspects of an ambitious post-LHC possible programme. The emphasis of the study is on a 100 TeV proton collider to be housed in a 80-100 km new ring in the…

Extending the sensitivity to New Physics beyond the anticipated reach of the LHC is a prime aim of future colliders. This paper summarises the potential of an e+e- linear collider, at and beyond 1 TeV, using a realistic simulation of the…

The upgrade of the normal conducting (NC) Radioactive Ion Beam EXperiment (REX)-ISOLDE heavy ion accelerator at CERN, under the High Intensity and Energy (HIE)-ISOLDE framework, proposes the use of superconducting (SC) quarter-wave…

In order to study the dynamic response of the material and the physical mechanism of the fluid dynamics, an accelerator scenario which can be applied to hard X-ray free electron laser and high energy electron radiography was proposed. This…

A Free Electron Laser (FEL) facility utilizing a recirculated Superconducting Radio Frequency (SRF) linear accelerator (linac) provides the opportunity to achieve about five times greater photon energy than an unrecirculated linac of…

The normal conducting Annular Coupled Structure (ACS) is applied for 190-400 MeV part of high intensity proton linac for the J-PARC. The ACS operating frequency is 972 MHz. The J-PARC ACS is strongly based on the results of previous…

ANL and the National Science Center "Kharkov Institute of Physics Technology" (NSC KIPT, Kharkov, Ukraine) jointly proposed to design and build a 100MeV/100KW linear accelerator which will be used to drive the neutron source subcritical…

The Compact Linear Collider (CLIC) is a proposed TeV-scale high-luminosity electron-positron collider. For an optimal exploitation of its physics potential, CLIC is foreseen to be built and operated in three stages, with centre-of-mass…

The present status of suggested linac-ring type ep and gamma-p colliders is reviewed. The main parameters of these machines as well as e-nucleus and gamma-nucleus colliders are considered. It is shown that sufficiently high luminosities may…

The physics, and a design, of a Large Hadron Electron Collider (LHeC) are sketched. With high luminosity, 10^{33}cm^{-2}s^{-1}, and high energy, \sqrt{s}=1.4 TeV, such a collider can be built in which a 70 GeV electron (positron) beam in…

The low-level RF (LLRF) systems for linear accelerating structures are typically based on heterodyne architectures. The linear accelerators normally have many RF stations and multiple RF inputs and outputs for each station, so the…

A new approach for a compact radio-frequency (RF) accelerator structure is presented. The new accelerator architecture is based on the Multiple Electrostatic Quadrupole Array Linear Accelerator (MEQALAC) structure that was first developed…

The Compact Linear Collider (CLIC) is a proposed future high-luminosity linear electron-positron collider operating at three energy stages, with nominal centre-of-mass energies: 380 GeV, 1.5 TeV, and 3 TeV. Its aim is to explore the energy…

The SPIRAL2 superconducting linear accelerator (LINAC), which has been operational since 2019, employs superconducting, independently phased RF resonators to deliver a wide range of particle beams. Designed for flexibility in particle…

I present here a new ring-ring design of eRHIC, a polarized electron-ion collider based on RHIC at BNL. This alternate eRHIC design utilizes high repetition rate colliding beams and is likely able to deliver the performance to meet the…

We propose an innovative linear accelerating structure, particularly suited for hadrontherapy applications. Its two main features are compactness and good power efficiency at low beam velocities: the first is achieved through a high working…

Linac-ring type colliders will open new windows for both energy frontier and particle factories. Concerning the first direction, these machines seem to be a sole way to TeV scale in lepton-hadron collisison at constituent level. An…