Related papers: The Effect of Temperature on Cu-K-In-Se Thin Films
We report the physical properties of Co$_2$CrAl Heusler alloy epitaxial thin films grown on single crystalline MgO(001) substrate using pulsed laser deposition technique. The x-ray diffraction pattern in $\theta$-2$\theta$ mode showed the…
Varying the substrate temperature changes structural and magnetic properties of spinel ferrite NZFO thin films. XRD of films grown at different temperature display only 004 reflections, without any secondary peaks, showing growth…
The present study reports on the structure formation in thin epitaxial nickel-aluminum films (Ni1-xAlx; Al atomic fraction x up to x=0.24) grown on MgO(001) substrates by magnetron sputtering. Experimental and computational data demonstrate…
Detailed KMC-MD (kinetic Monte Carlo-molecular dynamics) simulations of hyperthermal energy (10-100 eV) copper homoepitaxy have revealed a re-entrant layer-by-layer growth mode at low temperatures (50K) and reasonable fluxes (1 ML/s). This…
The preparation in thin film form of the known icosahedral phase in Ti-Ni-Zr bulk alloys has been investigated as a function of substrate temperature. Films were deposited by Pulsed Laser Deposition on sapphire substrates at temperatures…
Bulk EuPd$_2$Si$_2$ show a temperature-driven valence transisition of europium from $\sim$+2 above 200 K to $\sim$+3 below 100 K, which is correlated with a shrinking by approximatly 2 % of the crystal lattice along the two a-axes. Due to…
The structural and magnetic properties of Mn5Ge3Cx films prepared at elevated substrate temperatures TS are investigated. In particular, films with x >= 0.5 and TS = 680 K exhibit a strongly enhanced Curie temperature TC = 440 K compared to…
This investigation deals with the effect of annealing temperature on the structural, topographical and optical properties of Zinc Oxide thin films prepared by sol gel method. The structural properties were studied using X-ray diffraction…
Thin films of Co2MnSi have been grown on a-plane sapphire substrates from three elemental targets by dc magnetron co-sputtering. These films are single phase, have a strong (110) texture and a saturation magnetization of 4.95 uB/formula…
The effects of Mg deficiency in MgB2 films grown by using hybrid physical-chemical vapor deposition were investigated after vacuum annealing at various temperatures. High-quality MgB2 films grown on c-cut Al2O3 substrates with different…
Monophasic and homogeneous Ni10Zr7 nanocrystalline alloy films were successfully grown at room temperature by co-sputtering in an indigenously developed three-gun DC/RF magnetron sputtering unit. The films could be produced with long-range…
Motivated by recent advancements highlighting Ta as a promising material in low-loss superconducting circuits and showing long coherence times in superconducting qubits, we have explored the effect of cryogenic temperatures on the growth of…
We have grown single crystal samples of Co substituted CaFe2As2 using an FeAs flux and systematically studied the effects of annealing/quenching temperature on the physical properties of these samples. Whereas the as-grown samples (quenched…
Quantum computation based on superconducting circuits utilizes superconducting qubits with Josephson tunnel junctions. Engineering high-coherence qubits requires materials optimization. In this work, we present two superconducting thin film…
MgB2 thin films were deposited using Pulsed Laser Deposition (PLD) and ex-situ annealing in Mg atmosphere. The films presented critical temperatures up to 36K and turned out to be preferentially c-oriented both on Al2O3 (r-cut) and MgO(100)…
Pulsed laser deposition from a Nd:YAG laser was employed in production of hundreds of nanometer thick quasicrystalline Ti-Zr-Ni films on glass substrate. The influence of deposition temperature Ts on the structure, morphology and…
We report comprehensive angle-resolved photoemission investigations on the electronic structure of single crystal multiple-layer FeSe films grown on CaF2 substrate by pulsed laser deposition (PLD) method. Measurements on FeSe/CaF2 samples…
We investigate the synthesis of kesterite Cu2ZnSnS4 (CZTS) polycrystalline thin films using cosputtering from binary sulfide targets followed by annealing in sulfur vapor at 500 {\deg}C to 650 {\deg}C. The films are the kesterite CZTS phase…
We report the growth of potassium-doped BaFe2As2 thin films, where the major charge carriers are holes, on Al2O3 (0001) and LaAlO3 (001) substrates by using an ex-situ pulsed laser deposition technique. The measured Tc's are 40 and 39 K for…
As-deposited and unencapsulated GeSe$_{1-x}$Te$_x$ ($x = 0, 0.25$) 3-$\mu$m-thick amorphous films on Si(001) were obtained via the co-evaporation technique to study the effect of selenium (Se) substitution for tellurium (Te) on the GeSe…