Related papers: SOI RF Switch for Wireless Sensor Network

A positive ion source with RF discharge in solenoidal magnetic field is described. In this paper we present an overview of positive ion production in saddle antenna (helicon discharge) radio frequency (SA RF) ion sources. The efficiency of…

In this paper, a rectangular-shaped power divider has been presented operating at 27.9 GHz. The power divider has achieved acceptable results for important parameters such as S11, S12, S21, and S22. The substrate employed for the power…

We report a high performance nodeless hollow-core anti-resonant fiber with a broadband guidance from 1050 nm to >1900 nm, a transmission attenuation of 200 dB/km, and a low bending loss of 0.25 dB/m for a 5 cm radius at wavelength of 1550…

A novel wireless microstrip-based RF sensor designed for detecting changes in ionic content of water and the addition of solid contaminant objects is proposed and demonstrated. The sensor can be installed on the exterior wall of dielectric…

The coexistence of heterogeneous cellular standards (2G-5G) in shared spectrum demands sophisticated RF source separation techniques, yet no public dataset exists for data-driven research on this problem. We present RFSS (RF Signal Source…

This letter describes a 40.68 MHz wireless power transfer receiver for implantable applications focused on minimizing tissue heating. The system features a novel power radiated efficiency optimization strategy and a fast-settling active…

This paper proposes a new coil configuration that uses solenoid ferrites on the receiver side instead of planar ferrite coils that are employed in existing wireless charging systems.The solenoid ferrites are used in the drone legs to help…

This paper presents an always-on low-power wake-up receiver (WuRx) that activates the remainder of the system when a wake-up signal is detected. The proposed receiver has two phases of waking up. The first phase uses an integrated CMOS…

We develop an efficient back gate for silicon-on-insulator (SOI) devices operating at cryogenic temperatures, and measure the quadratic hyperfine Stark shift parameter of arsenic donors in isotopically purified $^{28}$Si-SOI layers using…

This project introduces a groundbreaking approach to address the challenge of periodic signal compression. By proposing a novel adaptive coding method, coupled with hardware-assisted data compression, we have developed a new architecture…

This paper presents current control method for a grid-connected partial resonant soft switching inverter. This inverter does not use an electrolytic capacitor and is capable of boosting and bucking the voltage. Grid-connected inverters are…

While positive-intrinsic-negative (PIN) diodes are commonly used in radio frequency (RF) circuits, their use often degrades the signal-to-noise ratio (SNR) due to high insertion loss and interference from additional biasing circuit…

In this paper we present the design, manufacturing, characterization and analysis of the coupling ratio spectral response for Multimode Interference (MMI) couplers in Silicon-on-Insulator (SOI) technology. The couplers were designed using a…

The present work focuses on experimental investigations of a bistabile silicon-on-insulator (SOI) micro-ring resonator (MRR). The resonator exploits a continuous-wave operation of the carrier-induced bistability demonstrating a stable…

The objective of this research was to design a 2.4 GHz class AB Power Amplifier, with 0.18 um SMIC CMOS technology by using Cadence software, for health care applications. The ultimate goal for such application is to minimize the trade-offs…

We present systematic measurements of the quality factors of surface acoustic wave (SAW) resonators on ST-X quartz in the gigahertz range at a temperature of $10 \, \textrm{mK}$. We demonstrate a internal quality factor $Q_\mathrm{i}$…

We propose and demonstrate a low-cost integrated photonic chip fabricated in a SOI foundry capable of simultaneously routing and amplifying light in a chip. This device is able to compensate insertion losses in photonic routers. It consists…

This paper discusses early results associated with a fully-digital direct-conversion array receiver at 28~GHz. The proposed receiver makes use of commercial off-the-shelf (COTS) electronics, including the receiver chain. The design consists…

Estimation problems in wireless sensor networks typically involve gathering and processing data from distributed sensors to infer the state of an environment at the fusion center. However, not all measurements contribute significantly to…

This paper presents two innovative four-port probe stations developed by FormFactor Incorporated (FFI) and MPI Corporation (MPI), and a four-port calibration standard design up to 125 GHz for the probe stations. True four-port probing at…